Search results

You should have called to make sure it would fit for you the muffler says it is Silent Exhaust Systems Aftermarket Muffler for Briggs & Stratton Zero-Turn V-Twin Engines. Take it as a lesson learned and pay the fee and get the right muffler

I put the steel ring around the nut then put the 2 bolts in and then heated the nut then put my pipe wrench on and the 3 foot bar, the ring held on the nut and prevented the pipe wrench from marking the nut this nut was tight

I was able to get the ram nut off with a bit of heat and the tool I made worked great, I took straight steel and shaped it round to fit the nut it took time but turned out good then all I had to do was drill 2- 3/8 holes in it and cut 2 bolts and it lined up in the pins on the ram nut. The...

how is the motor bearings ? does it happen when motor is warm ?

The fitting on top of the gun you can fill it from bulk grease using a grease pump. If you dont have a pump you can unscrew the top and put it in a pail of grease and slowly pull the bottom arm on the gun out to **** the grease in

Great job must have had lots of patience for the letters

I always use varsol and a stiff parts brush

I only use steel pipe for my lines only thing I can say is to try and tighten the fittings more and I think they are a compression fitting so I dont think you need to use and pipe sealer

I have answered some of my own questions I was able to get the packing box nut off what a dirty mess and pieces of the old seal. That end nut on the ram is tight I made a tool and tried to turn the nut I broke my bench trying it was an old cabinet that was beefed up many years ago. I will use...

If the store took your sockets and kept them they owe you either the old ones back so you can go to another store or to replace them. I would talk to the manager

Like I said I did not see it was 200 ' from the house so that is why it needs to drop to #1. #2 is rated for 100 A but not for this case

I have some more questions I hope I can get some help with Do I need to take the packing box nut off ? # 34 and the end cover #27 and does it unscrew ? do I need to polish the ram and the piston they have very minor imperfections on them and how smooth should I get them. Do I need to take...

I have had my CP almost 20 years never had a problem with it thats what I would get

something is not right it should only take 5-6 mins to fill the tank. Make sure you dont tighten the belts too much or it will wear the bearing you should have about an inch of play in the belts

I did not see the length of run as being 230' so yes #1 would be what is needed

No you do not need 1/0 wire # 2 al is what you need

The motor you are looking at is 3450 RPM you need to find a 1725 RPM motor and that motor wont work for you look at the picture it mounts wrong that is for a pump of some sort it has a C frame mount look for a a 213 frame motor.

I have a used 3 phase motor and I cant even give it away so if you have a buyer for the motor for 200.00 then it might be a good deal. How is the pump and the tank ? That is a good sized pump so I dont think a 5 HP would be big enough I think you would need a 7.5 HP for it but it may work on 5...

5 HP motor should be 23 amps #10 would work but myself I would use #8

I went looking for a wrench to take off the ram nut nothing local so may take a trip and see what they have. I wonder would a hydraulic shop have the tool and would they loosen this nut off for me