Search results

I picked these up recently. They are 14" long, 1 1/4 tall and .065 thick. Apex and Karflex brand. How old are these? Were they used on a regular hack saw or are they some kind of industrial blade? Thanks for any info.

That won't work, has to be end cut blade.

I have always bought cheep Menards house brand oscillating saw blades. They work ok but I am doing some cutting on wood that has hidden nails in it. These blades are pretty much done as soon as you hit a nail with them. Are the better blades able to withstand hitting a nail or do they go...

I am trying to check if it is the battery or the charger that is bad. I can get decent reading on the battery but when I test the charger with a multi meter it doesn't work. I have other brands of batteries and chargers and they do the same thing, batteries check out fine but not the chargers? I...

Anyone know what this is. I have a few of them in different sizes. There is supposed to be a o ring in the groove I marked in red.

I am looking at an old Smith 100 pull behind air compressor. It has a 302 Ford engine on it. It runs on one bank of cylinders and the other compresses the air. I have always wondered how they keep in balance? Anyone know?

I don't have them.

I tried two different gauges, same result.

I have 150 psi in my air tank but I can only get 110 through the regulator. I have tried two different regulators and 2 different gauges. Both regulators are 3/4" in and out. Any ideas? thanks

That was quick. That is them. I used to have a pair of sbc valve covers cut out for doing that. Thank you

Anyone know what this is? It was with a tool lot I bought.

I don't know what it is supposed to do but if you look at the video I posted it shows it sparking where i have it circled.

I found this on the internet. They only address the top part of torch. I am assuming the bottom part is not serviceable.

Anyone know what makes the spark on these? The problem is no spark in the lower circled area.

Thanks RTM. Yes, 10 + 12. Not sure why i typed 20. In my terrible drawing the top is .630, that other is a reference line.

Thanks guys, found it. Whitney 12 and 20. https://www.trick-tools.com/index/page/product/product_id/6561/category_chain/42,52,375,825/product_name/14+inch+%28E+Drill+Size%29+Round+Punch+and+Die+Set+for+Roper+Whitney+No.+10%2C+12

I will be at my shop tomorrow and get some pics.

I checked them, way different.

I have not called them but I did email them last week but have not gotten a reply.

I have a Whitney #11 rotary punch. I am having no luck finding punches and dies for it. I have seen some that are similiar but not the right ones. Here is a rough sketch (excuse the art work, not my specialty). Measurements are close using a cheap caliper. Any ideas? Thanks