Search results

Almost finished up the automatic to Tremec TKX swap. Just have to bleed the clutch and install the driveshaft.

Only about 200' or so away. Just right for me.

Wanted to try TIG welding for a while. Good reviews at a decent price. Ill give it a whirl.

It's a huge help for sure.

Serviced the tractor today so it's ready for the winter. Only ran it about 20hrs since last winter. Hopefully we have a mild winter again here in New England.

Assembled the new chair. I have to say it's pretty sweet.

Just got ahead and get it. Life's too short. Being Fathers Day today, there's lots of lifts on sale today. Get it ordered!

Getting the interior back together. Headliner, seats, carpet, center console, etc. Seats are higher than original so I'll have to pull them back out and come up with a solution.

I'm in! Thanks

Got the trailer all rewired and the roof sealed up.

More like "next" to the garage but... Used some rust convertor/primer on my trailer roof. Galvanized panels have surface rust. Good considering it's 25 years old. Found mice have decided to move into it. I evicted them but now working on the clean up. They decided to chew thru a fair...

I have the Atlas XH-PRO9000. Its considered extra tall and extra wide. I park my daily under it everyday. Bought it from Greg Smith Equipment in 2018. I paid $2830 including shipping. Same lift now is ~$5k. Haven't had any issues with it. Sounds like I'm using mine in the same manner you...

Rebuilt the carbs on the car. Looks like the fuel absorbed some water. Been sitting for a bit but.....

Put up a few more wall hangers.

Installed tonneau cover and bug deflector.

Looks to me like installation failure. If they removed the prior driveway, but didn't compact before laying the new mix, I can see it failing quickly. Also, if they didn't take the time to properly compact the base mix then compact to top layer of mix, this can be the result. In New...

Resurrecting an old thread..... Trimmed the windows in the shop. Now deciding on paint color.

I'm going to rewire and use the 50amp per manual. Manual shows max draw at 45.6amp. Probably never use it with all burners on max, but pretty easy to access wiring in basement so I'll just do it and be done. Thanks all for the advice.

It just has 2 wires and a ground.

I need to replace the existing 40 amp breaker with a 50 amp per the instructions with the new cooktop. The also requires increasing the wire size from 8 awh to 6 awg. The existing wire is 3 conductor. I found the white neutral is just capped in the junction box where the appliance whip is...