Search results

Pulled the front rotors off the wife's car today. They were pretty frozen on there. I was able t get them off with a ball peon while rotating the rotors. One off I noticed that I left pretty deep dings on the back side of the rotors. I dropped them of at Oreillys and asked them if there was...

I was cleaning out the garage and found these wrenches that I forgot I had. I bought them about ten years ago. They have that weird half jaw on the open end to allow a sort of ratcheting action while spinning a fastener. Are they worthy of space in the tool chest or are they gimmick type...

Does craftsman make an upgraded rebuild kit to make these ratchets smoother with a higher tooth count? Tired of having to get a fastener finger tight just to get the mechanism to ratchet back so I can turn the damn bolt.

Used a 14mm combo wrench on a fastener today. The fastener had a semi rounded off edge and I put the open end on the bolt. I could feel it start to flex and the wrench popped off. I measured the jaws with. my dial calipers and the open end measured 0.010 wider than the pocket. I measured the...

You know, the one that replaced the orange red crinkle finished one? I liked the one that they are blowing out at HF(crinkled finish one) until I noticed how much the drawers flex under a modest load. As of now I feel the 36in husky SS combo is best bang for the Buck but I'm really leaning...

What kind of hard mechanics tools have you actually broke while using? What where you working on? How were you using the tool? What brand tool was it? Not looking to start the COO war back up. Just looking for real life stories in the service bays and home garages. I'll start: I was...

Hey guys. I'm new to this forum but not to tools. Over the last 20 years I've formed a small collection of tools consisting of craftsman, husky(the older built in USA stuff), channellock, visegrip, and cresent. My basic concept is if you can bust you knuckles on it then then it better be good...