Search results

It's a Porsche 928 part. My usual Porsche parts house doesn't have 'em.

I'm looking for metric "3,9 X 13" ovalhead sheet-metal screws. By my math, that'd work out to a #7 X 1/2" U.S.-size screw. Any thoughts for finding such screws in either metric or U.S. size? Thanks, Mark.

Thanks for that advice. Crossing GSE off my list of possible suppliers.

Anyone know of a source for aluminum quarter round ~.75"? It's to finish my garage floor.

My garage door remote (rolling-code type) operate my neighbor's garage-door opener (fixed-frequency type) every few clicks. Any suggestions for correcting this on my end?

I wondered this too. My new workshop is 4" higher than my old garage, so I built in a concrete ramp that rises 4" over about 3'. I was concerned about the transitions from horizontal to ramp to horizontal. I talked with Racedeck, and they scratched their heads audibly before suggesting that...

Thanks for the replies. The cabinets weigh several hundred pounds empty. I don't think I'm going to be hanging them off the wall.

We're in the middle of putting Racedeck in the garage / workshop, and my assistant pointed out that it might make more sense not to put flooring under where the cabinets will be (I thought we would floor the whole workshop and then put the -very heavy- cabinets atop the flooring). Any thoughts...

Is it this one?

Here's a dynotile retailer:JNK Products (inauspicious abbreviation). $2.89/ft^2.

I just joined; I found this place after the slab was poured on my new garage addition. I wish I'd found it before, because I've discovered lots of great ideas that are going to drive my builder crazy when I propose the changes. The addition is a 16X22X12 space in front of one of the parking...