Search results

That one got used at least a couple of times. Sent from my iPhone using The Garage Journal mobile app

I got this at a garage sale the other day for $10. Looks like a lighter duty Wilton 5”. What do you all think about these? Sent from my iPhone using The Garage Journal mobile app

I’m reeeallll jealous of your drill press & mill! Sent from my iPhone using The Garage Journal mobile app

[emoji106] Sent from my iPhone using The Garage Journal mobile app

What did you do "IN" your garage today? Put tires on my ‘59 GMC and installed a new powermaster starter. Spaced it properly, but it still sounds like a cat being bred by a bull. I guess I’ll have to get a new flexplate. Sent from my iPhone using The Garage Journal mobile app

Here’s a couple of pictures I took tonight of my lift to wall distance. Closer than I like, but plenty of room to change tires. Sent from my iPhone using The Garage Journal mobile app

Nice. I didn’t have the ability to do that to my lift. Tried though! Sent from my iPhone using The Garage Journal mobile app

[emoji106]. I agree Sent from my iPhone using The Garage Journal mobile app

I can squeeze between my column and wall, and wish I had built my building a bit wider. 2' minimum if I was to do it again.

Nice job!

My cell phone case has one built in.

Got a little done this weekend. First layer of rock is spread on the east side and my 500 gallon propane tank is now connected. We have heat!

My 15 year old, Zach (A.K.A. “Taco”) has been working on his ‘88 Bronco II project. Here’s a few pictures.

I found this little vice on the slab where our old farm shop burned down back in ‘99. Looks a little better now. I wish I would’ve taken a before picture of it.

Finished my rotary phase converter project. It works great! I powered up my old Marvel 4B power hacksaw just fine.

A buddy went to an auction last weekend and gave me a beer flat full of tooling, etc that he figured I could use with my old lathe. These things were in with the tools, but I’m not sure what they are. One appears to be a drill bit stand. It has the hole sizes stamped in it. The other 2...

I think I’ll make a mini anvil out of the remains.

The brand is Fuller. Made in Japan is cast under the base.

I was using it to hold a 5/8” diameter rod so I could run a thread die over one end of the rod. I just cranked it a little too tight. We have a big vice bolted to a workbench at the farm that’s been sitting outside for about 15 years. Balloo or something like that is on the side of it. Don’t...

This was an old freebie vice that I bolted to the workbench a while back. Made in Japan. Folks, this is why you should buy quality USA made tools. Look how poorly this thing was made.