Search results

I love my valves. Put them on mine and the girlfriend's car and got my dad one for his truck. I usually drive up onto ramps in the driveway and then put jackstands under the frame and a large piece of cardboard under the engine before draining. I got the valves with a ****** on them and just...

I'm still waiting on mine. No signs yet. Sent from my PH-1 using Tapatalk

Nothing showed up for me yet. Is someone able to let me know if they've posted that it was shipped? Sent from my PH-1 using Tapatalk

Getting mine packaged up tonight and will be stopping at the post office tomorrow to send it out.

Swapped the ripping blade onto the table saw last night and ripped the last 3 pieces of maple down for my bar trim. Cut so much better and no burning. Might just run the last two pieces through with a skim cut so I don't have to sand as much.

Ripped two pieces of maple for the trim on the bar yesterday before realizing I didn't put my new ripping blade on the table saw. Swapped the blade this morning and will finish ripping the other pieces while I work on sanding out the burn marks on the first two.

Looks good. I brewed a Bell's Official kit this past Saturday and put it into my new fermenter. I'll be kegging a Citra Pale Ale tonight. Then I have a hard cider to keg also. Honey Porter is already in the kegerator and carbonated ready for Christmas. Have to finish off the two kegs of Hazy...

One of my items for my SS is arriving today. Need to head into town to get some local items for him as well before I can send it out.

Why doesn't Astro make motorcycle specific tools?

Got the butcher block pieces cut to length, sanded, and test fit in the bar I'm building in the basement. Next step is to get them sealed and then installed so I can get the trim fitted up.

Right, I should have expanded to say that the thimble will handle the clearances through the wall. Sent from my PH-1 using Tapatalk

Get a wall thimble to use with the CAT III vent. That will satisfy the combustible clearances.

Got some sheets of pre-finished UV sealed 1/2" plywood cut down last night for the bar build. Have 2 more "side" pieces to cut tonight and then start getting it attached to the bar.

Count me in again!

Thanks! Ordered what I needed online for pickup while I'm out of town. Sent from my PH-1 using Tapatalk

Anyone know if 11% is continuing next week? Sent from my PH-1 using Tapatalk

Got some more wood cut to length and pocket holes drilled for the basement bar build. Got most of it together, just need to measure out the spacing for the dividing "walls" between the pull-out garbages and the mini fridge.

Got some 2x4's cut and assembled to start building out the bar in the basement. Going to work on it a bit more tonight depending on how long it takes me to get my mailbox fixed (hit by a car last night).

My Menards carried Saf-T Vent in 4" diameter that I ended up using. I had to get a 3" to 4" adapter as well. Buying the pieces separately ended up costing me around $225, including the stainless wall thimble. Menards has 11% rebate going now as well. If you are planning to vent horizontally you...

1. I have the 50k and my heater came with a 3" exhaust so I had to get a 3" to 4" adapter for the Saf-T Vent that I used. 2. The Mr Heater manual should give you a minimum vent length and the minimum distance it needs to be away from any overhangs/soffits. 3. I used a Tee Termination on mine...