Search results

As said above, replace with longer screws, 2 to 3 inch to get into the studs.

For a hard-wired system, here's the contacts you need for your door. https://www.seco-larm.com/product/sm-216q-gy/

I would use Rockwool or similar for the ceiling. Better fire rating and acoustical properties.

As said above cut at 22 1/2 and glue joint. https://www.amazon.com/dp/B09DFCZ49R/?tag=atomicindus08-20

Go to the city, county, etc. and get a copy of your house plat map. All easements should be shown.

Small ceiling fan works wonders. Turn it on after your done and let it dry out the room. Mold is a thing of the past. Regair Ceiling Fans with Lights, DC Motor 22 inch Low Profile Ceiling Fans with Remote Control, Reversible Blades Small Black Flush Mount Ceiling Fan for Kitchen Bedroom Dining...

Purlins?

As said above DON'T pour in cold freezing weather. Allow the concrete to cure the full 28 days before exposing it to freezing temps.

The Dude:

What is upstate?

There is still some water, if it freezes it won't be good.

Did the concrete supplier warranty the mix? Did your concrete guy warranty the pour? My guess is, they did not. Good luck, you need 28 days to fully cure. Don't let it freeze in those 28 days. Some turn out fine, some not so much.

If you build close to your 250 year old tree you may kill it anyway. You may alter its ground water and starve it or flood it. With big trees it can take 5 to 7 years for this to happen. Good luck.

A set of pull down stairs for attic access: https://www.homedepot.com/p/Louisville-Ladder-Energy-Efficient-10-ft-12-ft-22-5-in-x-63-in-Insulated-Aluminum-Attic-Ladder-with-350-lbs-Load-Capacity-AL2240LG-R5/327684466

This appears to be soffit venting. Now you need to create or confirm you have a ridge or roof vent. You should be able to see them from inside the building. After you install your ceiling and insulate make sure the soffit vents do not get covered. Baffles are available for this purpose...

It all depends on what type of soffit and ridge venting you have, if any.

Is a drip leg not required anymore?

Buy a Weber grille.

What brand of door opener cost $3400.00?

I've done this. Use a small drill bit and very carefully drill around the circumference of the broken extractor. Keep at it untill you can pick the broken extractor out. Very tedious but it works. Now try a new extractor, be sure to turn this one clockwise.