Search results

Maybe I'll just daylight it and let me neighbor behind me deal with it.....

I would if the ditch wasn't uphill from me. And yo my surprise when I dug th holes for the pole foundation I hit sand about 2ft down and non of my holes filled with water. Won't be at the swap meet. Need to get my garage done before I bring anything else home....

The drum would be underground as be used as a drywell. I figured it would hold a lot more water then a gravel pit underground

I am in process of a garage build and the final planning stages are going threw my head. I have about 80ft of house gutters that I'm unsure what to do with. Before my garage the pipe just daylighted into the side yard. Now after the garage that is right where my driveway will be. I can plan...

Do you think 9 of these would light up a 26x40x12 shop ok? From my research that would be around 115fc.

I highly doubt you will have the welder set to use 20a. That's prob will do 3/8 thick metal. I know I'm gonna take some heat on this but just put a 20a outlet in your garage. If the breaker pops your pulling more then 15a. (That is if its a 15a circuit) Hey that's what breakers are for

My garage is coming along great. Been doing everything my self. But I have never done a stone veneer before and am wondering if I should put my vinyl siding on first or do the stone wainscot first.

Use. 2/2/2/4 mobile home feeder. It needs to be in conduit above ground and inside. And can be direct burial

Mines 40 deep and I made the back 18ft level and the front where I will be parking a var is sloped to a floor drain. A good rule for slope floor is 1/8in drop per foot of floor

4in concrete over 25psi board is fine

I would stress to them that the door doesn't seal right because of the bad concrete. It looks like it takes a lot of force to get the door down. That weather strip is completely smashed on the sides. It ***** that you keep having issues with your build.

Thanks guys. And the picture isn't on my house just used it for reference. Is the SER ok for above ground in conduit? Now where to get the pcv ******?

The ser is gonna to go into the house right under my panel. And that side of the house doesn't look good anyway. Have a cable and phone and service entrance all right there. The only time I'll see is is when I mow

Is it code to mount a J box outside the house and drill thru the back of box into an exterior wall? Here is where my question comes from. I am running MHF for a service to my garage. It is not aloud indoor in open air. I have a finished basement and running conduit would be a pain. I plan...

I has crushers run in mine for a few months and its solid

My concrete guy is concerned with the pex floating too. Especially when I told him I want the system pressurized

When I had my door installed I went with the bigger radius. I have 10 ft doors and 12ft ceiling. The high lift would have got me 2in closer to the ceiling then the bigger radius. Wasn't worth the price difference for that little gain. Also you can only get so close to the ceiling.

Just take the brace off the door and see if it sags when up. I am thinking the c channel on the bottom will prevent that. Oh and once you take it off you won't want to tell anyone here you did.

Similar as to knock "something" up? Ha OP, are you planing on a brick or stone around the doors where siding is missing?

My CPA said asked me about a driveway to my garage. He is planning on writing it off when I do it