Search results

CONNECT your switch as follows: 1 side of the switch goes to the black on the outlet and the other side goes to all the blacks from the soffit lights. the whites are correct on the drawing

how about a broom finish to aid in traction?

are you checking the voltage under load or just in the socket? if you check it under load are you getting 240 volts?

It's used as a t-handle or a small breaker bar

just connect the other bank of lights to the black and white wires at the light

that is athermal time delay relay. It's kinda old school

thought about a couple of horse stall mats in the "landing zone", then I have dollys from harbor freight. Use 3 of them., 2 with 2x3 screed on for the skis and 1 under the track. ,

As I finish the snowmobile area in the basement,I am having a hard time trying to figure out what flooring to use. The skis and picks are hard on the floor, (this is a ride in garage area). and the sleds bring in a lot of snow with them. this means lots of water. Floor area is flat not sloped...

most of those bulbs can be "switched from one base to the other without problem, as you kno how to remove them just get some replacements from wally world and change the base to match

have you tried reversing the wires on the switch for the craftsman. leds only work in one direction and the opener may be a ground switch not a hot swicth, Just a though

I ant to add some under floor radiant heat to the bath above the garage. there is baseboard heat in there now, could I break the loop and add 3/4 pex or other tubing to the floor between the joists and return into the loop/Of course there is insulation in the joist bays.

I as told that outlets should be 6 ft apart max so that you don,t need long extension cords. this was in the house . good idea with 2 circuits, I have 4 circuits in the garage 1 on each wall and 2 near the work bench wall (back)

if you want to weight it. 4 bathroom scales and put one under each wheel. add them up for the total. put the weighrt in the front or the best place to balance the car . more in the front ill cause it to accelerate down the ramp .

Check the neutral attached to the switch Needs it to light the light, see this alot in units where the ground is missing causes the switch lamp to glow

make it like a shower curtain ,use conduit for the rod and shower style hooks to hang a curtain. like welding curtains

did my trailer in bedliner (roll on) the trailer is 10 years old and still going strong

looks like either moisture or a chemical residue, How high was the humidity on the day you did it?

according to wicapedia it is a permenat match

first version of a lighter. the wick is the dipped in some flamable liquid and stored in the hole until it is needed

just used one of those cheap razor knifes, the one that the blade extends out an you can snap off to keep sharp. used straight edge and extended the blade and cut the 2" board clean. get a couple because you will dull them.