Search results

Hello Everyone, Some time ago I posted a question regarding the wiring of a Millers Falls bench grinder. I received a lot of good advice and got the thing running in no time. Well, that same grinder has been sitting unused because for the life of me, I cannot find a left-handed threaded nut for...

I restored a Delta/Milwaukee bandsaw that was given to me in pieces. Motor works and it's wired for 120V. My issue is I don't know how to go about making all the connections. The bandsaw has a little bell light with 2 wires going out. It has a switch with 2 wires going out. It has a junction box...

I have a Shop Fox drill press. I like all it's features. The fact that it oscillates is very handy to me when sneakying up on a measurement on a curved part for a guitar. In my quest to further eliminate run out I'd like to change the chuck AND the arbor but I don't know how the arbor on this...

Good Day Everyone, Does anyone out there own a Millers Falls #216 hand drill? If so, I would kindly ask that you post a photo or two. I really would like to repair the one I own. The quill does not auto feed. I thank you very much.

Good day Everyone, I purchased this Millers Falls 216 drill. It's in good order except for the fact that it does not auto feed when the hand crank is turned. The parts that make it auto feed appear to be missing according to the few photos I've been able to find. I don't know how these parts...

I have a Millers Falls bench grinder that I restored. The plug cable was dried out and had exposed wiring. I replaced the toggle switch and the plug cord. I should have taken a photo to remember how the toggle switch and plug cord were wired. I placed the cord black lead (hot) to the motor wire...