Search results

This is similar to what I was leaning toward, have any pictures?

Looks like the Festool Domino patent expire in June(13th?), and Kreg is ready. Curious if it will drive Domino pricing down… Kreg Edge

Curious to see everyone's stairs for second levels/loft etc. Curious to railing options, fully enclosed vs ???

I see what you are getting at. With said i was thinking of my insulated doors which are heavy, no way you are lifting them without some spring assist. I will say I like the deadbolt noise, I can I can tell if the door has opened for some reason, and same when it closes.

I think we are saying the same thing, I just phrased it poorly. The person I quoted indicated that since it was a jackshaft opener it wouldn't hold it closed, only the weight of the door holds it. I was trying to say that the door has almost no downward weight when setup properly, and that the...

Well in that case there is almost no weight on the door, due to the spring being set for the door to hand open. I believe the unit does keep it from being opened, as that is why there is a release to disengage to open in the case of a failure.

Darn, I drove through KC in Feb, and didn't even think to stop...

I think the correct answers is yes there is a thing as too much torque, and the result is you get to spend a bunch more time working on whatever you are working on. Right, so many broken bolts.... I would say breaking off is much more likely then stripping/rounding as standard hex bolt...

How about this…

Picture below, correct they are very expensive new. All I was pointing out is that the used market is a great resource.

Ah makes sense, thanks for the answer. I know on the one sub, all the circuits go out the bottom, hence installing it on the bottom.

Do you have a sketch of the tie in to the house of the attached version. Does the attached have full footing vs detached with floating slab? Electrical in both?

Curious why 2 and not a single one? In my subs(I have two), I have put a single bar at the bottom with a lug added for the feeder ground wire(ground wire in the 4 wire feeder)

I would say straight knives leave a nicer finish, but they are loud and if you damage one then you need to change them(both or all 3). Helical can be damaged and you just rotate the cutter, you also get 4 cutting edges so carbides last a long time.

Are they arc fault breakers, or combo AFCI/GFCI breakers. I believe that due to the electronics inside an AFCI breaker they are typically warm.

Is there a natural break point in the cabinet to have a double still. I have done face frames up to 12ft long with no issues.

4. Why you bought it 5. What you told your SO you paid for it

Are these plastic for vehicle trim/interior work? Have a PN?

It is fairly clean, the only real issue is the paint on the top is worn, seems like a design flaw not to have a cover. It sat on Kjiji for almost 3 month before I bought it.

Yep, Here is a picture of it in my garage, I was mid project, excuse the mess. It has a segmented head that the previous owner installed. The reason it was cheap was due to snip issue/board not feeding. Issue was incorrectly adjusted pressure bar. I tore it down, install new bearing all...