Search results

How do I discharge it beforehand? Just cut both the wires then discharge by grounding it out?

Here’s a pic.

It’s weird it will start and run fine until 30 or 40 lbs then kick the breaker on the machine not the circuit breaker. I watched the vids about the run capacitor it may be that, I took it apart and it looks like the wires are epoxied directly to it with no serviceable connections.

Checked the belt this am. Tension is good.

Yes, still the same.

Not a compressor expert. Where is that and how do I check it?

I have a IR garage mate air compressor that wont fill all the way. It stops running at around 75 pounds and trips the breaker. If I drain the tank it will run fine until it hits that point. Ive done a search and haven't found a lot of info. I was using it to run a roofing nailer with a 10...

I had a rough inspection on my electrical and he passed the trench part. He told me to put 15 amp tamper proof plugs on my 20 amp out let circuits, which I thought was weird for a shop. Is that okay? seems like I'm missing some capacity if I do that. On the advice of friend who's a master...

Everything I've read is the the vent is supposed to run downward away from heater at 1/4" per ft.

I've been thinking about that actually. We'll see. The plan is to do stained cedar or similar in the recessed area where the door is.

Been busy with this project. Today I was trenching for power. The hydraulic trencher was broken at the Home Depot so I had to muscle the manual one. SUCKED! If you're ever trenching get the hydraulic one your back will thank you. I've been roughing in the electrical and buying lighting 2X4 LED...

Excellent, thank you gentlemen.

I've looked and searched but I couldn't find an answer. I want to dim 6 LED flat panels. Do i just run the wire to the first fixture and that will dim all of them? Or do I need to daisy chain them or run a 18 gauge wire from each one individually to the dimmer switch? Sorry for the newb question.

I also posted this in the electrical section as I'm sure to get some answers from the guru's. I'm putting some low profile led lights as a secondary light source in my modern studio build (link) and wanted to ask how I should go about wiring them up to pass a rough electrical inspection. They...

I build and make all kinds of stuff. Here are a couple of my past projects. I also build tables. Heavy *** industrial tables. www.detroitable.com This is what some clr and elbow grease will do to heavily oxidated paint. The Vespa was a full restore as It was too far gone.

I'm putting some low profile led lights as a secondary light source in my modern studio build (link) and wanted to ask how I should go about wiring them up to pass a rough electrical inspection. They obviously need drywall to be installed. So do I just leave wires hanging in the place I want...

Thanks Dave, leaving the hard stuff to the pros. Still stressful.

We broke ground on the shop this week so there's no turning back now. Dug the footings 42" deep and filled with concrete. The form in the pics is just roughed in. The guy digging the footings looks to have the worlds first skid steer. I looks like **** but worked like a champ, so no complaints...

Made an intro video for this garage build project. Should be entertaining.