Search results

Thanks! That is a great photo!

Got the tools put away and cleaned the bench.

Not today, but Saturday. Took the plow/ tire chaines off the CubCadet and put the deck back on. hopefully next weekend the weather will be nice enough for some mowing.

I didn't put an led in. I did replace all 4 bulbs while I had it apart.

All of this to replace a marker light:

Not today, but over the weekend. Started getting the bikes ready to the season. These two got the oil and transmission fluid changed, and started getting cleaned up (primary fluid looks like new). Had to murder an oil filter to get it off. I know I put it on hand tight! Also found that the...

Changed the oil in the commuter car (again), installed a wire wheel on the Wen 1800 bench grinder someone gave me years ago. Cleaned tools, put tools away, drank beer, have about 90% of the benches cleared and cleaned.

My daughter gave this one she had from welding school. I dont know anything about it. Seems to get dark when i press the "test" button.

What helmet are you using?

Sorted a wood pile that will be moved to the "lean too" this weekend. Put the tools away from replacing the head gasket on the tractor. Organized my old Matco tool box I brought up from the old house with welding ****. drank a beer, had a cigar

Thanks for the tip. I’ll haveto look into it. I really like the bottle mod you made

Yes. I have a few Harley touring bikes (FLH). I was looking for a welder that I could weld sheet metal, mostly for body work (I have to replace the rocker panels on my Sliverado) . I settled on a mig welder from eastwood. Its a 120 volt welder that will allow me to weld up to 3/16 plate. I...

Good Luck! I am going to try my new mig welder this weekend. I haven't welded since high school

I can’t complain about the motor. It been abused and is about 8 years old. It was fine when I lived in the city with 3 lots, but after moving to the sticks with a couple acres. It was just too much. I have replaced it with a larger cub cadet, but would like to get this running again for basic...

Put the head gasket and new carb back on the Husky rider. Fires right up, but surges the stumbles and gives a puff of black smoke before it dies when throttling up and down. May clean and try the old carb Had and to find a source or a replacement head gasket. The ones in received from...

1,2,3....

Took the head off of the Husky riding mower. head gasket definately blown, head doesn't seem warped though. The oil smells like it has gas in it. ordered a new carb and gasket set.

Cleaned up, unpacked the new welder and built the cart.

Detailed the Silverado. Not to bad for 10 years old and 100k

Put all the tools away (again), cleaned the benches, and swept the floor. Getting erady to tear into the engine on the Husquavarna riding mower.