Search results

another set to pass along. cman USA dbe polished 12 pt UNUSED #44316 - 44320 $125 shipped USPS priority to lower 48. check, pp friend

time to sell off my drawer queens. set of 7 wrenches, UNUSED, in their pouch. Craftsman polished lockable flex ratchenting wrenches, USA, #24655 - 61. stamped (-kz-) $250 shipped USPS priority, check or pp friend.

still available

menards. they're peg holding brackets, for hanging garden tools, special pegs required. mounted opposite how they were intended. 4' lengths (seems 4' aint available ennymore)...

not those. usually whatever is on the mag strips on box side. craftsman, masterforce, klein yes, im a tool *****. again, another tip of the iceberg

thanks tip of the iceberg

:love: problem solved, cleaned with mineral spirits, spritzed with gloss urethane

i see no pics you mean the black one thats in the middle of my picture? (which has the screw holding claw broken off) limited production run they also made limited production green ones look up the channey thread, you'll see my collection, up to that point. haven't bought the new gen drivers yet...

with osha and epa restrictions

off topic.......... use a wood shim or a wider blade putty knife between the hammer and walla walla on topic............ this is gj. get 2 tool chests and fill them. with duplicates of triples. report back after.

i kinda like fluke

i see i wrote tin. whaddi know about sheet metal? im a fitter aluminum, steel, same ****, break out the band aids, i see blood in my future. my bad

a zip tie

you're going to excavate, next to the base layer just put in?

that, is excellent! thanks for sharing

just bought 6 pony pipe clamps for stupid little munney - $6.73 each, +11% most likely getting more, cant have enough clamps! also, the led's aren't too bad. a little big, but i have a place for 'em.

those most likely, as my sets, are cadium plated. do not handle without gloves (ya wanna add to your collection? i got 3 sets or so, with ratchets)

rivets leak. screws leak. no clearance, clarance galvanized spray (i dont know why id ever use it in this case) is the wrong color no velding, its on flashing already installed on the house. and its 30 gage. thin aluminum. i was able to make a bigger piece, bent a 90 on 1 side, and slid it...

well? didja get it out? odds are not by unscrewing it. its better to cut them out.

i have a few places, on the my houses' flashing, i'd like to join 2 pieces of tin, without a screw or rivet. i don't want to perforate either/ both pieces. on a diy store bought sheet metal fitting, you can see (4) 3/16 punches / divots that hold this side of the tee together. malco's site...