Search results

Hello all, considering grabbing a Jet 3 in 1 brake/shear/roller. I know as a general rule mixing machine capabilities just leaves all functions less than great. Only doing minor panel replacement for body work. Question for anyone that has one. Rated at 20ga. I assume if only working with a...

Hey all, I've got a propane unit heater in my shop that the kids seem to leave on. My tank is 100 gallons so if I'm not out there for a couple days it can empty and not cheap to fill. I can see the shop from the house and want to put a light on the shop to see when the furnace is running. Is...

Hello all, just installed a used Worth 9000lb 2 post lift in my home shop. The arms seem to sag a little. They don't bow or bend but do not stay square to the upright. I assumed the 2 plates that go over the tube had spread over the years but on measuring them they are the same at the inside...

Hello all, picked up a slightly used Worth 2 post lift the other day. Good deal but no install instructions. Can't seem to get a response from worth by email. Any chance one of you happen to have this lift and maybe some paperwork on them? I dug extra deep areas in my shop before my floor was...

Now that I say it out loud it sounds unreasonable. I've got 208v 3 phase in my shop and I found deal on a nice plasma cutter that only runs on 400/460 3phase. Is there some kind of converter I can use to run this equipment? Thanks, 1

Hey all, not sure if this is the place to ask but figured there was a lot of knowledge on here. I've got a 5hp IR T-30 compressor. It flips my panel breaker when it gets to around 60psi. I pulled the pump and opened it up, seems very clean and smooth. Put it back together and still the same...

Hey all, I'm planning my shop build and am debating between a mono and a traditional slab floor. I can do the excavation work but will have to hire out the forms/labor. I'll be building the rest of the shop myself so the concrete will be a rather large part of the total cost. I like the idea of...

I've been looking for a new home shop compressor for a while now and I ran across a Ram Air 2 cylinder 60 gallon upright for about $350. I found almost no info online so I thought I'd ask here if Anyone has good or bad to say about this compressor. Any input is appreciated. Thanks, 1

Hey all, my impact was really weak in reverse so I took it apart to look inside. When I was disassembling it 2 little "keeper" type things fell out before I saw where they came from. Can anyone help me out here? Anyone know where I can get an exploded diagram? On a side note I didn't see...