Search results

I am trying “clean up” my base area on one side of my garage. The right side was easy but the left has low block foundation wider than the wall. I was tempted just to paint it and then glue a qtr round to the block to cover the gap. Or had thought about adding wood base with a 90 degree...

Ran into a small problem when installing my race deck. I have a 2 bay garage with 2 separate doors. 1 door sits 5" back from the other. It was an addition done years ago. I had bought the edging pieces, but I need to cut a tile for one of the doors, and that leaves no way to interlock the...

I am planning on mounting my compressor in my shed and then running lines to the garage for the air. I have been looking at the Maxline and like the idea, but I was concerned about not being able to put a drain at the lowest point of the run. I have seen the setups with the black steel pipe...

So I bought an Atlas BP9000. After getting the columns mounted, we noticed that one of the mounting plates on the carriage had been flipped and welded incorrectly while being made. So I contacted the dealer and let them know of the problem. The sent out a new carriage. Upon looking at this...

Getting close to ordering and was wondering if anyone in the Baltimore/Annapolis area that has Racedeck flooring would let me take a peek? Just want to get a look at it installed and also walk around on it to see how I like it. Thanks Ryan

I added a garage about 3 yrs ago and pretty much stalled on the finishing. Finally getting around to the inside. Original thread - http://www.garagejournal.com/forum/showthread.php?t=1844 I used Sherwin-Williams Shield-Crete Epoxy last fall. OK results. Hard to get a consistent color and...

I am most likely getting ready to rent an Edco floor grinder w/ diamond cutters. I degreased the floor yesterday. Originally I was going to acid etch and then grind to smooth it out. I had a couple of bad patch jobs. After doing a little bit of reading, it sounds like I can skip the acid...

I ran out of time before the weather change to epoxy my floor. I will now have to wait to spring time. I have one car that leaks a little bit of oil. Until I get a chance to take care of that, I was wondering if the was a large "rubber" mat that I could purchase as a temp solution. Right...

Here are some pics of my ongoing project. This was started in Aug 2004. Still working on the garage (along with a lot of other house projects) The garage is 28' x 40'. 10' ceilings. It is set up for floor heat, but not yet hooked up. I am working on getting the floor epoxy done this week...

test Test