Search results

What I have is a hand held tachometer that my father in law had used forever, until he died of old age. It's been sitting for ten years before I was able to use it. Anyone who has one of these little gizmos, I need some help, when I place it on the engine belt, it maxed out the RPM's. I've...

I'm now at the third project.... The table saw, and I need to get some information about it. The shell as we spoke about it before has a hole cut out in the side panel, I want to replace it, now, will any 113.XXXXX fit it? Will a 8" saw shell fit it???? Thanks for any information. I've...

On my delta scroll saw I have a leak. I need some advice on how to properly repair it. I know in 1930's they didn't have what we have today, I'm sure they used leather to seal the saw. The leak is here in the shaft, the above photo. Model 700

OK, I have the manual, and I'm working on the scroll saw, however the crank case plug location is where? Is it the "Steel Pipe Plug" on the drawings that is the crank case plug? The manual helps, however it is from another time and sometimes I have a problem with old scrolls from the dead...

I'm on to my next repair, the table saw, it's in good condition considering that the owner messed around with it. This is how I found it the motor was on the table so I assumed it belonged to it. My mistake. I removed the table from the shell. Someone cut a large hole in th skin of the...

I have a motor that I need to identify and repair if possible, it is for a table saw. The parts are missing for the motor. If I can find the manual it would give me the parts I need. 3450 RPM 115/230 Volts 60 Hz 10/5 Amps Phase 1 If I need to replace the motor, I could, it's...

Well I did it, I was able to save this band saw, service it and it is running good. The upper wheel guide has a crack in it. I'm not really sure which way I want to repair it, I can fabricate a new part, or repair the damaged one. Maybe someone has a solution? The lower bearings were...

Band saw made by Craftsman, 1930-1940 era. I found the manual. Table saw made by Craftsman, 1950's era. I found the manual. Delta scroll saw, model DSS2 and I can't find a manual for this one. I need to find out what motor will be correct for running the scroll saw, and what saw blades...