Search results

Can someone please link me this part or provide the name of it? I have tried clamshell but not finding anything close to this part (see image). Thanks

Hey all, I have a project of adding an immersion heater to a water based solution to clean suspension parts. The cleaner is: simple green aircraft & precision cleaner at a ratio of 1 part cleaner to 3 parts water The immersion heater is: Briidea...

Hey all! For those of you that have used the POR15 rust preventative and then did the 320 grit sand paper in preparation for the POR15 Top Coat, did you find the Top Coat to lay/flow out differently than the rust preventative did? I want the Gloss Black Top Coat from POR15 to look smooth when...

Hey all! I am in the planning phase of building my trailer. I’ll be building it in my garage and I have a question on the beginning of the build. How do I ensure that the frame is on the same plane when I build it? I thought of using a laser level and make sure every location I measure from...

Hello, I am planning to install a MaxJax lift into my garage. My slab is 4" thick, 3500psi, with structural grade beams and wire mesh. The instructions for the lift calls for at least 4.25" slab thickness, 3000psi, and steel bar reinforced concrete. So, I don't meet the minimum requirements. I...

Hello, I am considering getting a lift in my garage at home. I have done some research and read some forums but looking for up-to-date suggestions if anyone has them. I will be mostly working on a small cars and light trucks. My ceiling is 10.5 feet high and the lift will go in the center of a...

Hey all, Moved my air compressor into my shed behind my house and ran 3/4” ID Iron Pipe from the tank up into the garage. I plan to have a 50’ air hose but 3/8” air hose seems like it will choke the volume of air off with the 1/4” npt ends. Should I care about this or go bigger on the hose? I...

Hey All, I am having a hard time finding the info I need so I apologize in advance if this was already covered. I made the mistake of running braided line from my compressor head to my aftercooler. Eventually I noticed that the compressor was running longer and longer. The rubber inside the...

Hello, I have a single inlet (no outlet) on the top auto drain water separator. It has a float in it that moves up and drains the water out. On top of the canister there is a valve that can be turned which would seem to let air out. What is the purpose of this valve! Thanks

Hello all! I am new to the site and am wondering how to setup my compressor with an after cooler. I have a big problem with water coming out of my air tools and I eventually want to paint my car. I have a Kobalt 3.7-HP 60-Gallon 155-PSI 230-Volt, 11.5 SCFM at 90 PSI Vertical Stationary Electric...