Search results

Legacy 850 sometimes both sensors are lit and it works fine, other times one is blinking red and the other is off It will go up but not down unless u hold the button on the wall unit Wires look ok but not 100 percent Can I bypass these sensors ? Is this a bad sensor ? Thank you

Seems like around the outside perimeter the crusher run has sunk some so you can see the pressure treated sill Also it feels like in spots you can put your finger under the concert floor from the outside .. Almost like there are voids under the floor This spot was very well compacted and...

I have a 28 x 40 x 16 pole barn and would be interested in a good one

They seem pretty decent They look tall enough I won’t even have to extend them Welds look decent Thoughts ?

I would like to do it more for sound deadening than anything Don’t really want the cost of spray foam Thinking more like foam board screwed on the bottom of the trusses ? Or what’s the plastic covered stuff stores like Dollar General etc use ? Suggestions ? Thx

So I think the max psi before it stops is 150? But sometimes when using air impact I feel it lets the psi get too low before kicking in How best to adjust that so it stays at a higher psi

I have a Chicago phnematic 1/2”drive but it doesn’t seem to have a lot of power Don’t want to spent a ton of money Whacha think

All my cordless tools are rigid 18v I’d like to buy a subcompact impact just to work on cars etc Seems like all the videos I see now the techs are using them . I’m thinking a 3/8” would be best I’m not planning to use it for lug nuts as I have a compressor and air impact Thoughts ? Thx

So I have a fridge in my uninsulated barn , I have beer and water in it . My electric bill is usually 24.00 a month and 22.00 of that is minimum charge . Im sure it’s gonna run a lot because it’s 100 Degs at times inside Anyone else have a set up like that

I have a 25 yr old CP 1/2” air impact It’s getting tired I don’t use it often but are any of the Harborfreight ones worth looking at ?

I have a 28 x 40 x 16 pole barn that I’d like to put a four post lift in I have a 1/2 ton Silverado and two suvs Basically do oil changes , undercoating , ****** fluids wtc What a good quality 4 post ?

Going to buy some black FF to undercoat my truck Wonder if the HF guns are any good

In a mild rain storm it’s deafening inside , hot as hell in the summer .. I’d like to park a motorhome inside and have it stay above freezing . I’m in Cayuga County NY What are your thoughts on hiring it done , best method , any names in my area ? Thank you

Ok I have a 28 x 40 pole barn with 16ft walls We are selling our house and if we can’t find another may have a travel trailer inside the pole barn until we do It’s cold here in NY in winter .. Now what would it cost to put a steel siding ceiling in and insulate above it and spray foam the walls...

I have aprox 30 x 60 parking area that is crusher run . This time of year with the freeze and thaw weather there are areas where it’s soft and rutted . Also from using my tractor with the loader it’s scraped some off etc So am I best off just getting a half load of crusher and spreading and back...

Wonder if these would work good to holding sockets ? I have a coupon for 2.50, Is that the best coupon out ?

I was thinking about a 4post movable lift but the good ones are like 5k...and for doing oil changes and ****** fluids that probably overkill I could do it with Quick Jack and also do tire rotations etc

They are both made in China

Ok at my home garage I have a large roller box full of all the tools i need,,, all Snapon , Craftsman.Matco, all older stuff.. I have a 28 x40 pole barn 1-1/2 mile away from my home where I keep my truck, tractor and 4 wheeler Every time I need something I bring it from home .. it’s a pita I...

I use my pole barn to store my tractor, truck, 4 wheeler mowers etc..may someday have a motorhome or trailer .. I live in Fingerlakes area of NY...Ive had it up two years...it VERY loud during a rain storm... Thought about having it insulated with spray foam or something under the roof deck...