Search results

I had 2x CP56HPWP 56in Canarm Fans installed in the shop. They are wired into a single Canarm variable speed switch w/ reverse. On minimum speed, they are still turning to fast. The manual says there is a minimum speed adjustment screw. Can someone help me out and tell me where this screw is...

I just installed a Daikin 19 Series 24000btu Mini Split earlier this year. I used the A/C all summer with no problems. I started using the Heater last weekend and have it set to stay at 62degrees. It does a great job maintaining temp in the shop, but for the second time this week, I have come...

Platonic asked for a review back when I posted buying these lights, so I just wanted to give a little review on the Greenlight depot 2ft High Bay 110W. I went with 6 in my 24 x 24 shop. These are great lights and put out a lot of light, especially for the money. I have had them up since January...

I have been searching the forum for awhile now and I would like to get advice from the experts. I have a 24 x 24 red iron building with a 6" slab. There is no vapor barrier installed under the concrete and they used a power trowel to finish it. I am looking at sealing it because I will be doing...

Well after all the advice I gathered from here, I finally got my new Daikin Mini Split installed. It was a little different installing on a red iron building, but it all worked out good.

I am about to pull the trigger on a 24,000 btu mini split for my shop. I have it narrowed down to either a LG- 21.5 seer or a Daikin- 18 seer. They are within $100 of each other and the Daikin has a 10 year warranty compared to the LG's 7 year warranty. I was hoping to get some feedback on...

I am in the process of finishing a new 24 x 24 x 12 red iron building and could use some advice. I have not decided on a brand yet but I have read through a lot of threads over the last 2 weeks. What size should I get with a 12ft ceiling? I am looking at a 18000btu or should I go 24000btu? It...

I am building a new Red Iron Garage. I am wanting to know about wiring. I would like to run 3/4" or 1" conduits from where my panel will be located, under slab and stub up in each bay in the walls. I will be lining the walls with metal. I would like to run the electric behind the paneling in...