Search results

Been looking for a lathe for excavator pins recently. need single phase at my shop and came across this one Enco 13x40, 220V single phase, comes with 3 chucks and various tooling. He's asking 3600, what do you think?

So I finally am figuring out my boiler but now. However if it runs for 30 minutes or more, it starts to drip condensate down the intake into the heater? What can I do to fix this, it terminates to a Concentric vent about 12' above it? I researched for a vertical condensate drain and can't find...

Hey Guys, I'm wanting to do a final improvement to my shop and get my Backhoe/Trailers covered but out of the shop. Seems the best way to do this is add a lean to at the gable end. I was going to Cut the existing sidewall steel and install a Gable Vent while I'm at it for attic access since I...

So I'm about to tackle sweating up a boiler panel for my Radiant floor. I'm basing all of the design off the youtube videos provided below that greatly helped me. I'm traveling for work so I have my evenings with basic tools away from home. Give any advice or pointers you see as its a first for...

I'm trying to finalize the HVAC plan for my 40x48x16 Barn, Just insulated with R50 in ceiling and R9 from blankets in the walls. I really need help with the AC. originally I was going to pursue a 2.5 ton AC unit and air handler like this post...

I've finally decided to bite the bullet and install a cieling with insulation on the bottom of my trusses in the shop. I want the avaliability to heat and cool and that would really help out greatly. Below I had some questions if some people who have done this could share some lessons or...

So I've been slowly building this barn back home in indiana. Never done radiant heat before, but Im slowly learning. 1. I cinked a pex pipe when I was laying a circuit, it may hold pressure. But you think I should I should splice a new section in? 2. I cut out the insulation to make a deeper...