Search results

My Quincy AirMaster QT-5 Baldor motor went out last week so I ordered a replacement Baldor L1410T with a 1 1/8" shaft. This is beefier than my old motor so I'll need a new pulley. I know I need a 7.5-8" pulley to work with my 13 or 14" pump pulley to get around 800-1000 RPM, Now my...

I have a Quincy QT5 Air compressor with a Quincy 202 pump and Baldor 5hp 21 AMP 230V motor. My problem is it recently started tripping my 30AMP breaker after its already been run and built up 150-175 PSI then the pressure drops because of use and it kicks back on to rebuild pressure. So it...

Anyone given it a shot yet? I have some dents on the lip of my hood where I cannot get too with a hammer and dolly and I was thinking about giving this a try. It has no reviews on the HF site so I thought I would ask here. Has anyone tried one? How well do the work?

my 20x22 attached garage floor has cracked 1/4 to 1/2" crack right in the middle and sank slanting backwards to the back left corner towards the house. Its been like this for a very long time 10+ years, the home was built in 1973 and previously had a water drainage problem between the garage...

I have a 5hp 60gal single stage speedaire compressor and I just got a good deal on a speedaire 2 stage pump off a gas powered unit that the motor went bad on. I got it for $80 bucks and now I need to know what is needed to convert this thing to use the new pump. Normally I would just say...

found great deal on a New inexpensive plasma today. I bought an Italian made yes Italy not China, Harbor Freight 40amp pilot arc plasma for $220 bucks found it on Craigslist. Never used but was missing the ground cable, Borrowed the one off my ARC welder. I love it, It will cut 1/2" which...