Search results

I already posted in the wanted thread however I know not everyone looks at it. I'm in need of some Devron 224v light grey epoxy kit or a partial amount for a few small repairs on my floor before I put polyurethane on. I should of held a little back now I can't find it anywhere.

Im in the need of Devoe Devron 224v light grey epoxy kit or partial amount. I have some areas I need to repair and I can't find it anywhere.

Wanted to see by chance if anyone have New Age Bold Series cabinets that I could look at before I purchase them. Can't decide between them or Ulti-Mate cabinets. Thanks

Just finished installing my Daiken mini split and had a local Heat and Air company vacum lines down and get it going. It is working fine in AC mode but in heat mode it the fzn will never ramp up and start blowing even when manualy Turned up. It hasa error code A5 which says could be clogged...

I just retired From Spirit Aero Systems in June and started building my 20 x 28 garage at sametime. I have a lot of projects planned for the future. The first project is Whipple Super charger install on my F150 SC. I plan on finishing it out and installing a Daiken mini-split in it. I have the...

I am almost ready to wire my 20 x 28 garage that I'm building. It has 10ft ceilings and I am planning on 6 of the Metalux 8293 lumens. I want it very bright are these overkill or not enough. I was Planning on running 2 rows of 3 lights.

Finally got concrete work done and framed up the garage over the weekend. This coming weekend I plan on installing roof trusses. I'm not sure where the bracing goes on them, and can't make out anything on the drawings sent. Garage is 20 x 28 so trusses are 20ft wide with 4/12 pitch. Anyone know...

Finally got concrete work done and framed up the garage over the weekend. This coming weekend I plan on installing roof trusses. I'm not sure where the bracing goes on them, and can't make out anything on the drawings sent. Garage is 20 x 28 so trusses are 20ft wide with 4/12 pitch. Anyone know...

Its been over 15 years since I done any framing. Wanting to know of any changes or special requirement. I know they have added some for walls with garage doors to meet shear loads. Anything else? My garage is going to be 20x28 my 9x8 garage door will be on a 20ft gable end with structural truss...

Im thinking about getting a whole house generator but not up to speed on them. I have heard about possible issues with Generac. Not sure about other brands.

Im in the process of getting everything ready for my garage if I ever get the concrete work done. Do I need 12awg on 20 amp for my outlets? 14awg on 15 amp is cheaper and easier to work with. I won't be running any high Demand equipment, occasionally small table saw, chop saw. Air compressor...

I have had these in my attached garage for 2 years now and no problems. They are very bright and look good. How many should I put in my 20x28 garage and can I run them all on 14 wire daisy chained on 15 amp breaker.

I getting ready to build a 20x30 garage and would like to heat and cool it. I going to put a 100 amp sub panel in it and would like to go all electric if possible. I would like some ideas, all in one units in the wall or other. Thanks Alan

Im build a new garage and going to sub feed it from 200 amp house panel. Approximately 90ft it will run through the house come outside and down through 1 1/4 conduit 18" deep in ground then back up to exterior of garage wall. I then plan on coming in the garage at the bottom of the wall and then...