Search results
-
E
Knipex Slim Knips
I found these on Mr Worker. For whatever reason, it says that they won’t ship Knipex to the United States. I can’t find them for sale anywhere. Knipex 78 61 150 Anyways… I just saw them a few minutes ago… and… I want them so bad…- ecotec
- Thread
- Replies: 23
- Forum: General Tool Discussion
-
E
Regulator at air tool
I need a small regulator that I can connect and disconnect to my blow guns, so as to not wreck things (sun roof gaskets, awnings… things that I want less psi without dialing down the shop air. Ideally, I would want just one that I could attach to different tools. Is there a favorite or...- ecotec
- Thread
- Replies: 20
- Forum: General Tool Discussion
-
E
Recommend bore brushes
Have you guys found that any brand of bore brushes, for use in an impact driver, works better than the other brands? This would be, mostly, for cleaning out brake slider pin ports. Obviously, they need to be the kind that work in 1/4” impact drivers.- ecotec
- Thread
- Replies: 12
- Forum: General Tool Discussion
-
E
Torque multiplier
What is a good torque multiplier? I have never owned or used one. A lot of the brands on Amazon look like they are made on the same tooling. The ExtremepowerUS and the Performance Tool ones have the most reviews. I was probably going to go with one of them… but I wanted to see what you guys...- ecotec
- Thread
- Replies: 7
- Forum: General Tool Discussion
-
E
Drill press table
What is a good factory made drill press table with an adjustable fence? It is for a bench top drill press.- ecotec
- Thread
- Replies: 19
- Forum: General Tool Discussion
-
E
What is this?
I have no idea what this is, or where it came from? I cleaned out a drawer, and it was in there. It says Blackhawk AZ1050.- ecotec
- Thread
- Replies: 3
- Forum: General Tool Discussion
-
E
Furnace not restarting itself.
My furnace will restart itself if I turn off the single pole switch on the side. The igniter will light up and the gas will start. Then, it will run, get up to temp… and then just the fan will be running but the gas will be off. So, it will get the house up to temperature. Then will not start...- ecotec
- Thread
- Replies: 12
- Forum: Heating and A/C
-
E
parts.cat.com
What happened to parts.cat.com? I have bought a LOT of tools from this site over time (7 socket sets, ratcheting screwdriver, 3 screwdriver sets in PAKTY…). It was like cheap Williams and Snap-on. The sockets look just like Snap-on except for the CAT logo. Some of the tools are even labeled...- ecotec
- Thread
- Replies: 23
- Forum: General Tool Discussion
-
E
Gearwrench XL vs. ICON, Mountain...
I have never had this style wrench before. I have regular length Gearwrench and 0 offset Snap-on ICON is the easiest to buy, as I pass HF pretty regularly. Gearwrench or Mountain I would have to order online. The thing that I do not like about the ICON is that they are spline. The Gearwrench is...- ecotec
- Thread
- Replies: 25
- Forum: General Tool Discussion
-
E
Hand box for every day work dilemma
Deleted...- ecotec
- Thread
- Replies: 13
- Forum: General Tool Discussion