Search results

Footing width should be twice what is on top. 8 inch block plus 4 inch face brick is 12 inches, footing should be 24 inches wide

Typically, a sewer would pass under the footing if the depth allowed. A septic line would pass through wall as they are much shallower. Here in Michigan our water needs to be 4 ft. deep. So on a full basement thru the wall, crawl space under the footing.

I recieved 12, yesterday.

Our rental company rents the mud mixer, $80.00 for 4 hours

Could they be tekton? Earily on tekton tools were produced with out branding. My crow foot wrenches come to mind.

Hardware cloth wrapped around pipe

Me too, stuck in Michigan near Lansing.

Last night I put a 2 pack of bucket lid mouse traps in my cart, price $9.99 Today log in to order, price $15.99 So much for prime day. Guess I should have order last night.

On the systems I install we drill 1/8 inch hole in the pipe in pump vault or tank. When running it sprays out a little, when pump shuts off it drains the line. A little loss of pump efficiency, but beats frozen line. I am surprised you are getting temperatures that would freeze. Our access lid...

I bought the ez red pliers a year ago for 19.99, who would have guessed that prices would go down.

It was a hell of a good deal

Try seal all. JB weld on a well cleaned, drained oil pan did not work for me.

Ok, I've worked on septics for 45 years. Need to drill 1/16 or 1/8 inch hole in the pipe, inside pump tank above the water. It will spit a little effluent when pump is energized. When pump shuts off water drains, hole allows air to follow, so you only drain what is left in pipe. We do a lot...

Same here

Get an LB 1 or LB 2. They are great made by lazer alignment. I have a few, these are real work horses. No longer made but can be sourced though pawn shop, Ebay, or market place. The original employees just installed a new battery pack in mine last year. First battery pack lasted close to 30...

Brain storming here with not much technical experience except owning a home with oil fired base board heat. What if a heat exchanger was installed and out going temp set for your RFH say 118 degrees and your boiler water could still be 180 for base board heat. No mixing valves required.

Nice work, looking good. I will check out the synflex tubing.

Only 10% off now or for me

My order date was May 8, updated arrival date is June 8th, looking at status it has not shipped yet.

In for two shovel handles