Search results

Dozerhand, that looks like the right solution. On demand pump with a built in pressure switch. Thanks for sharing.

Jswain has it right. Pressure washer works just fine when plugged in to the hose at the house. Working just great (and as designed) for 10 or more years. Not sure I follow the comment about burning up the pressure washer pump when connected to the hose bib. I’m just trying to mimic the output...

Any reason I couldn’t just plumb in a pump at the tank outlet then install a bypass valve...

Thanks No detailing, just want to be able to pressure wash where there is no water. I’m looking for a solution that doesn’t burn I up the pump if the trigger isn’t pulled.

I have a Simpson 3700 psi, 2.5 GPM gas pressure washer. I have a 70 gallon poly water tank (like what you find at Tractor Supply) and I'd like to make a small mobile pressure washing setup. Ive heard some say you can just use gravity from the tank to the washer, but I called Simpson and they...

Needing a 44” unit. Curious how people are getting the 25% coupon? They seem to have gotten way more expensive

I have a Jeep cj with t5 transmission needing rebuilt. Anyone have any good recommendations for shops local to the Kansas City area? Thanks

Seems there are two sets of holes to vary the width on the 9000 xlt and it’s not addressed in the instructions or videos. Any suggestions on what works best? Do you have to use both outer or both inner? Is it typical to just move the non powered track? Thanks Scott

Anyone know the closest thing to the Raptor Grab? Don't seem to be sold anymore.

Jkonz, do the Mr. Cool mini split from Costco. Hard to beat. Easy install and does the trick.

Jkonz. I’m in the Kansas City area and had very much the same issue. I would have mold on the wall, and at times moisture on the floor. Dehumidification is the answer. I have a mini split installed that I rarely used. I figured out it has a dehumidification mode. I run it round the clock in...

I can't seem to find the Raptor Grab liners anymore. Does anyone know where to get those or did they go out of business? Those are the best I've seen.

Any recommendations here? Is this par for the course on die grinders?

Bought an old CJ that I plan to fix up. 1976 cj5 was my first vehicle and I’ve always been partial to them. First order of business is repairing some rot. Not much experience so learning as I go. I already cut out some of the floors and side and have some repair panels coming. In the rear...

I bought a 90 degree Harbor Freight air die grinder to get in some tight spots when cutting metal. It bogs down and stalls basically as soon as it hits the metal. It's not an air issue (I have a 60 gallon tank, proper air pressure, and oil the tool). I know HF tools are cheap and I generally...

Are there more than one different types of base/clear?

Have an old CJ that I am slowly in the process of restoring. It's not a show car, so i'm wondering about painting it myself. I've dont a lot of projects, just not paint. How difficult is it for a beginner? Since I have to replace some parts anyway, would it be easier to pain the hood...

Matt, do you have any recommendations for cost effective options for the 3 stages?

Anyone use a devilbiss qc3? Is that sufficient by itself? Plasma manual notes the need of “3 stage coalescing filtration system”. Is that sufficient by itself?

I have the 3/4" rapid air in wall airline plumbing in my shop with 3 or 4 outlets. Need a recommendation for a good air line dryer. Not sure if that should be installed on the output of the compressor, or if i need something at each outlet. Use will be for a Hypertherm plasma cutter / table...