Search results

excellent thanks! Mine is air - and the vanes were shot- i have a new pump i can install..

The side it leaks doesn’t open or at least I haven’t looked- bead breaker works great but there’s an intermittent light hiss from inside - not very big and the machine works otherwise - I’ll try get some pics .. Good to know about the piston kit tx

Thanks all.. that really helps- as mentioned I’ve gone thru the valve bodies for pedals and lines- they don’t leak. That bead breaker box sounds like it’s the culprit- I’ll check that guys videos and post back. Still unpacking into new shop and need to get working asap as I haven’t earned a...

I have a coats machine i bought 2 years ago and havent been able to run it much due to lack of 220v for a decent compressor which I now have. I did clean and repair some small leaks at the various hoses and have a new pump i probably need to install as old ones vanes were worn (they looked like...

Upon further research the arms are longer on the wider lifts so ill just tuck the mirrors in -

Considering extending the overhead beam on my bendpak- I can make hydraulic lines not an issue there, but the cables go to both posts - possible there might be enough cable free length? mine came in two widths and considering extending it approx 14 inches to the larger spec

model # is XL-9C / same as the XL10C apparently

4wd or 2? mines a 4wd

this was a good deal on a used lift - in good shape.. im eye balling the bendpak 10k- not too bad new..

ill take some video and i believe i did let them know - could just be the post holes for the outside lifts.. either way already moved in

so i bought a lift from a guy whose been selling them for 30 years. Seems like i got ripped, cos ad said 9k for xxxx, called and he said he has a 10k only for $250 more. Gets delivered and guy says its a 9k, im like well i paid for a 10k. The he says bendpak discontinued one because the 9 and 10...

renting - thanks. ill look into tiles but would like to roll engine stands around with engines on soo... is what it is i guess

The bad section was quite clean for about 1-2 weeks, ie dry. Im wondering if I scrub it again and treat with something (acetone)? and try lay down a sealer of some kind that will keep the stuff below from weeping through? ** Been finding alot of good reviews on ghostshield- wonder if the 4500...

Hi all - moved into a new shop. Prev tenant did transmissions for 25 years and lets say he was not the cleanest guy in town. Scrubbed with commercial scrubber and gallons of very strong soap- Came out looking great- however the one side where I guess he was the worst, weeps wet oil spots on hot...

no but they are ugly due to carpet glue over the top - and **** up against a 4ft strip of tile we are removing- so we might end up in the 3/8" possibly even 1/2" thick range more so. ive moved shop and this will be front of house - wont see a lot of traffic- below vinyl is concrete slab so zero...

Moving into a new shop and there are really stuck vinyl tiles with currently 1/4" room for self leveling cement floor. This is not a heavy use area - just basically an entrance to walk on. They are not peeling at all and are superbly stuck- cant even get a hand scraper underneath- it would...

agreed was wondering about that- few pieces of pipe are cheap and there is a slight taper in the reduction, also not sure how important a factor the venturi plays in the metering valve. production ones have a long taper, diy ones use the short taper in the adapter 1-1/4 down to 3/4 or whatever size

agreed-

far as i can tell the sebastian is loaded with parts- incl steady rest

both have tailstocks, sebastian has steady rest and bunch of parts.. I wont be working these hard- just home hobbyist. leblond might have steady rest id have to ask..