Search results

There are too many reasons to run a lathe in reverse to try to explain, but it is critical to many operations. For example, I recently needed to cut an 8 degree angle on a part that was too large to feed from the front, so I reversed the lathe and cut the angle in reverse using the compound.

Great idea, I just ordered a tap. Thanks!

A used South Bend is less likely to break and is more serviceable that anything made in China, in my opinion. If you can build lego's, you can work on a South Bend.

Yes, the lathe would do what you are asking, you would be limited by the size of work that would fit in your chuck and the length of the bed and small cuts would be required. I suggest you consider a South Bend, you could probably get a good quality machine for just a little more that you are...

Try this for sealing irregular shapes http://www.eastwood.com/ew-flexible-strip-caulk-bk-2-lbs.html

Send me a drawing, I will make it for you.

I use a piece of 2X4 and two clamps. Clamp the tube to the 2X4 and cut. Or, sometimes I use a drill press vise. Clamp the tube in the vise and make your cut. Basically, look for ways to make your round stock square.

I buy left over remnants and bundles on ebay. You can get good stuff cheap that is otherwise throw away for a big manufacturer.

My order is in for both sets. Thank you for everything you have done to make this happen. Glove

Dude, You give "from scratch" a whole new meaning! Very nice.

I would like a set of each please. Thank you.

http://www.weldingtipsandtricks.com/index.html This is the most comprehensive "learn to weld" site on the internet, imo. You are getting very good advice.

You'll shoot your eye out kid! I like it!

Thank you everyone for the most helpful replies. Now that I know about the awning rail, I will run that along the top as suggested. For attaching the bottom portion I am planning to weld in a rail like the one pictured below. This shot is of a new awning I saw going up last week.

From http://www.weldingtipsandtricks.com/bolt-or-stud-extraction-comments.html "Put a nut over the broken bolt and place the mig gun on the nut, then while holding the nut down with the MIG nozzle, start welding. Fill the nut and when it cools, use a wrench to remove. I think it works so well...

They still make it and it is available from McMaster-Carr http://www.mcmaster.com/#catalog/117/3271/=fr3wiu

Thanks Mike13u, I am just up the road from you in Melbourne. The awning will be finished in Sunbrella canvas. Powder coat concerns me because I have nightmares of rust stains streaming down my walls. If I go aluminum, what size square tube do you recommend?

Hey guys, I am going to fab a custom awning for the door of my shop. The awning will probably be 6 feet wide, three feet deep with about a 30 degree slope. Since I live on the coast I will use one inch stainless steel square for the frame. What thickness square do you recommend? Thanks

I'm in!