I also found out tonight that the countersink bits I bought are not going to work for the frame bolts, it should have been obvious, but I just assumed that a 5/8” countersink bit would work for a 5/8” bolt, wrong, it is more like 1 1/8” bit that I need. I ordered an 1 1/4”, hopefully it will be here later this week. The Tru-Hitch has feet that need to load right where these bolts are on the top of the frame, I have been just trying to get them somewhat between them, but it really just needs to be flat. I may be able to use a drill bit to make it work, might have to take a trip over to the SG again, I don’t have any big bits at the Hill.



Everyone needs a 5 ton in the backyard, right?




Everyone needs a 5 ton in the backyard, right?




