Recent content by Bellaireroad

I went ahead with the press and a bearing splitter, and got the upper two bearings off. There is a steel carrier they are pressed onto (see pic), the carrier has a bronze bushing inside it. The carrier floats up and down on the spline and hits a stop when it moves to the top. Somewhat hesitant...

Hello,putting new bearings on my spindle, and got this far in disassembly. two snap rings are already loose. I have an arbor press but not sure which way to press on it and didn’t want to screw it up Thanks

Aluminum Alloy Stand Holder for USB/Wi-Fi Digital Microscope, Bysameyee Universal Diameter Metal Mount with Microscope Carrying Case (No Light) https://www.amazon.com/dp/B07VFNQ8MM/?tag=atomicindus08-20 Here’s what I ended up with

Great ideas. Thanks. That gives me options!!

Yes, something similar. Got a link?

Hello, I am looking for a rack and gear that will run on a 1/2 to 3/4 inch pipe or tube. The gear would run off a knob to raise and lower an indexing pin. anyone know where to source something like this? Have seen something similar for servo motors, but this will be used as an indexing tool...

👍🏻

Thanks, that looks like a good solution. I also need the motor to run for 12-18 hours at low RPM so epoxy can harden while rod turns. So on/off can’t run off foot pedal , any idea how to get the foot pedal in there?

Hello, I would like to wire a 24V DC motor for a fishing rod wrapper. I’m going to need a converter, and a speed controller, with reverse capability, and a switch to run either off a foot pedal or continuously off the speed controller. The motor I’m looking at will draw no more than one amp and...

Hello, I would like to wire a DC motor for a fishing rod wrapper. I’m going to need a converter, and a speed controller, with reverse capability, and a switch to run either off a foot pedal or continuously off the speed controller. The motor I’m looking at will draw no more than one amp and 25...

Thanks everyone

They might be, these are off of a rod lathe. Probably use them on sliding closet doors, shower doors etc.

Hey, Cobbler! They are on a tray that runs on a fishing rod lathe, I’m sure they have other uses. They are 25x10x6

Hello, I’m trying to source these rollers. Not getting them very many hits on Google. Anyone know the name for them? Thanks

Thanks, those steel dowels you made me a while back have come to good use! Sent from my iPhone using Tapatalk Pro