Recent content by bluejean

I have a Millermatic 200 mig welder that has a 5 wire Bodine drive motor model nsh-13d3. My drive motor is shot. Does anyone know how to test a Bodine motor with 5 wires to see if it works without putting it in a welder?

I have a Silver Beauty 8610 battery charger. Looks like it sat on a shelf for most of its life. I got it for nothing and it won't turn on. As I took it apart, I noticed that the external fuse rear connection has what I think is a fuse link coiled connected to the gauge. The so called fuse link...

I'm going to convert my sand blasting booth to a aqua blaster. Looking to buy a electric slurry direct pressure system pump that can pump 40 to 50 gallons per minute on a single phase. Any idea where I can get one?

I have a old Nike hydraulic 1 1/2ton floor jack model 302HD. My jack pumps up, but won't stay up. There's no exterior leaks, and the ram comes down quickly. Anyone know what will cause it to fail? And does anyone know where I can get information or a schematic on this model?

I have a 40 gal parts washer filled with Safety Kleen and need of a pump. What would be a good replacement at what gph?

Sorry the high build primer covered some of the numbering.

Do you know what ppg paint color matches snap on red?

It's got to be at least 30 years old. The slides are mostly friction and one ball bearing slide on the bottom draw.

Sat outside tarped and started to get surface rust. Needed to sandblasting and sanding.

This Snap on kr560 box is a $350.00 find, that I got on craigslist from eastern Connecticut. Time to disassemble and remove stickers.

What paint did you use to paint you toolbox?

I was wondering if anybody knows who sells a sand separating tube? The tube screws in the bottom of a pressure pot sandblaster, that keeps it from clogging and eliminates moisture that settles on the bottom. The tube is plastic with holes all around the sides.

How did you get the trim back on the draws without disturbing the paint and making them tight without falling off?

Thanks for the help!

I'm sorry snap on still makes the draw slides they call them runners. Although I don't see the aluminum corner pieces, and the aluminum draw trims. Any Ideas?