Recent content by Dspurlo81

I live in Oklahoma

I have a 30x30 metal building. Im installing a corrugated ceiling. It will be air conditioned and heated. Do I need to install a vapor barrier on the ceiling. I will be blowing in cellulose

What about where they overlap? Does it seal up tight?

It's true corrugated

What about where the panels overlap? Just screw the panels to each other?

I already purchased the corrugated panels. I just don't want to put them up, insulate and it sags. I wasn't sure how strong they would be on 5ft centers

So run 2x4s perpendicular then attach the sheet metal to it?

I'm installing 29 gauge corrugated metal for my ceiling. My trusses are on 5ft centers. I'm wanting to blow in 14 inches of cellulose. Will that be too much weight? Will I need to add bracing where the metal overlaps?

They have terminals inside that will work with 4/0? Sent from my iPhone using Tapatalk

The box will be 20ft from entry. Does someone make a outdoor junction box? Sent from my iPhone using Tapatalk

I'm running 4/0 aluminum wire to my shop. I'm wanting to terminate it outside then run copper inside. Is there a junction box or is this even feasible? Sent from my iPhone using Tapatalk

What brand did you use?

Anyone have recommendations for acid concrete stain?

Would this one work?

The old shop never runs over the minimum bill. I would like 200 amps at my new shop but wasn't sure if it could be done without fees thru lugs