Recent content by jerseydriver820

Karcher k1700 Sent from my Pixel XL using Tapatalk

Yeah, I understand it looks nice but it's not happening. I'm going with a breathable paint for concrete and want it done correct and once. All other paints on wet, or breathing surfaces are just damaging my foundation I sent out a request for a pro to soda blast. And I'll do the painting...

Id like to remove all of the paint from my basement walls. There are about 6 layers from the previous owner. Does anyone have a preferred method of paint removal to get all of this off effectively? So far there are heavy duty strippers and soda blasting. I'm hesitant to do soda blasting...

Looks like it's sodium nitrate Sent from my Pixel XL using Tapatalk

If you live in jersey, like myself. I have found 2 options for winter washing. You can hook your hose up to your hot water heater or ultility sink indoors. This way the hose bib outside stays drains and worry free through winter. Or install Prier C-144S10 Heavy Duty 10 Wall Inlet 1/2" SWT x...

One more question as I am really wanting to use epoxy, if I use heat lamps on the panels to increase the temp of the panel to over 65. Then shoot epoxy, and keep the heat lamps on. Will the cure times or product be effected. Temperature is my biggest obstacle at this time Sent from my Pixel...

Thanks Bob. Didn't even realize I had a douplicate post Sent from my Pixel XL using Tapatalk

Good question, I figured epoxy would provide a good smooth coverage that is thick enough to be used under a car. Also expand and contract at the same rate and be better suited for the job over the POR15 alternative Someone private DMed me and recommended a bed liner like raptor or herculiner...

Would you still recommend if I can't get the temp in my garage above 45 degrees Sent from my Pixel XL using Tapatalk

Since it's my first time. I think the exterior I'll brush it on Sent from my Pixel XL using Tapatalk

Are you shooting SPI through a gun. I have heard a lot of positive things of this product but since I'm so new I got intimidated by the site. Good tip on the weld threw primer Sent from my Pixel XL using Tapatalk

I'm looking for some advice. I'll be doing some work to my BMW, welding on the chassis and the interior. I'd like to finish the process off with an epoxy paint. A lot of people use POR 15 but I have reservations about the product. It also will look bad when finishing the interior. Does anyone...

I'm looking for some advice. I'll be doing some work to my BMW, welding on the chassis and the interior. I'd like to finish the process off with an epoxy paint. A lot of people use POR 15 but I have reservations about the product. It also will look bad when finishing the interior. Does anyone...

Hobart 140 is great because you can turn it down so low Sent from my Pixel XL using Tapatalk

Thanks for the response everyone. Looks like I'll be welding up a table for this over the weekend and getting some PSA disks from harbor freight to start. Very happy I asked here, thanks again!