Recent content by mailman62

thanks chetter

thanks mike

I am looking into regulator for the 100lb lp tank running to my mr heater 4500 , not sure which kind and dont want to get wrong one , I am looking at a mr heater 90 degree low pressure reg.soft nose pol x 3//8 inch female thread. Can this reg. work for me?

thanks guys

I am running about 10 ft of black pipe from a 100lb propane tank to a gararge heater and needed to know whats best for using on threads of black pipe , teflon tape or is there a special tape for this or pipe dope? also would it be a bad ideia to run the pipe down a extierior wall inside the...

thanks rick

got my mr heater 4500lp mounted and now looking at wiring for thermastat. I HAVE A 18 awg wire that has 5 different colored wires , should I just be using the red and white wires and disregaurd the others?

using a 100lb propane tank for mr heater 4500lp, wanted to know what type of regulator to use at the tank , can I use same type used for typical gas grill?:

thanks guys that was very helpfull

got a 4500 lp mr heater and vertical vent kit , my question is about vent kit,. it has two 3 ft. sections of single wall pipe and one section of 3 ft. double wall pipe, do I need to use the double wall piece? or can I JUST GO WITH THE 2 SECTIONS of single wall through roof right to the cap?::

I purchased a mr heater muh45lp and needed some ansewrs on install.I was planning to run it off 100 lb lp tank,what type of regulator do I need at tank connection? do I NEED A REG at all? AND not sure what to go with from there ,should I USE flex copper all the way to the universal hookup or...

I am new to this forum and came across your question , I am going to install the same heater in my gararge with same fuel source and tank, wanted to ask you about regulator and how that worked out ,did the 60kbtu size work? and did you use a universal hookup off the heater?thanks