Recent content by NickPrime

If time allows, please send a set of drawings (AutoCad 2000 DXF) to [email protected] - Many thanks in advance.

Mine has been on my finger for 31+ years, never off other than to have it cleaned. Never scratched anything. Had it hang on a door jamb once, had to have it cut off then. There are safety issues, but one must be careful as with all things in life.

Build your own. They are very easy to do, hing them at the landing and they can be drawn up out of the way. If needed a counterbalance and cable makes it easy to lift up.

http://www.cottamhorseshoes.com/home.htm Gas cylinders: Air Liquide America Corp - www.airliquide.com 9101 Lyndon B Johnson Fwy, Dallas - (972) 234-2371

As a member of more sites than I can recall, I only have this to say - stop printing it here, it does no good. If you want to write, then write those in power from your respective states - tell them what your issues are - get something done - become part of the solution rather than a...

http://http://www.lotusdoors.com.au/folding/timberfeat.html We have used these with good results.

Jeff! It's a shame you don't have anything to do........... What size is the building? Oh, and I love the old "Belt Lathe", I haven’t seen one of those in a few years. You certainly are well equipped. Doesn’t look like there is much you can’t do there. What state are you in? I need some...

If you have the following, small bench drill press you can make your own. Go to Home Depot or Lowes. In the area where they sell metal, i.e. aluminum angle, specifically 1"x1"x1/8"x36" and buy a stick or two. Now, trail over to the area where the wood dowels are kept, you nees a 1" diameter...

What's the Location?

Add a swing out, rotate 90º seat and foot pedal.

I would say from your drawing/sketch, it will be more in the neighborhood of $125+ sft. I don't know your location and that will influance the cost too. e-mail me the floor plan and I can get a lot closer. [email protected]

Welcome fellow Texan! It's a great place.

1000lbs, OMG! What are you going to put on it?! You can get the same size caster with locks in a 300 to 400 lb range and save a few bucks. Slick table though. Here in the Dallas area, we have several steel suppliers that have various drops for consumption. Worst case, pay to have it cut to...

Try your local Northern Tools, Lowes or Hom Depot.

Thanks Dave. I don't want to badmouth any competitor out there. Suffice it to say, regardless of what you purchase, Automobiles, Cameras, TV, Stereo or dog food, there are either sub-grade models with less to offer (amenities) or a lower priced version, including a metal shop building. The...