Recent content by Soccer918843

So I have the rockwool insulation all up in The ceiling and walls and all the tongue and groove pine just about completed on the walls then white tin will be going on the ceiling. I do like how the tongue and groove looks natural nice and light colored so I don’t want to stain but if I were to...

Hello will any of the newer cordless stick vacuums be handy or work well with sawdust not heavy amount but just occasional cleaning ect? Or does anyone have any recommendations I didn’t care for the dewalt cordless vacs

I’m in northern ny on the Canadian border my ceiling is 2x8 attic truss with tin going on the inside ceiling tin roof with it sheathed as well

When I googled it. It claimed it was 2 degrees farenheit that’s why I wanted the ecobee instead of the best which only goes down to 50 I hope that’s not the case

Damn! R53 I didn’t even know rockwool made anything that big that must of weighed a ton your building is gonna be super efficent I bet I used r 30 in my ceiling and r23 in the walls

I think your best bet is blown in or if the money allows spray foam

I am also planning to do this setup. Did you run 4 wires from the heater to the ecobee? I messaged them and they said the ecobee will work fine with that heater as long as 4 wires were hooked up

So I’ve finished insulating all my walls and applied a 6 mil vapor barrier question is do I install a vapor barrier to the ceiling too or no a lot of people say no so that it can breath.?

Ecobee got back to me and said I don’t need anything else just thr 4 wires to run that heater correctly

So I purchased my heater , vent kit and got a very good deal on a ecobee 4 can I use this too run the heater or do I need a social relay? I keep reading that it’s recommended to use a relay with it even in the Manual or was this years ago and is not needed now? Also when running my thermostat...

So I have many other best thermostats in the house and figured I would get one to match for the garage, I purchased a c wire adapter plug to get around that and planned on using my new nest 3rd gen on it but then I looked at the ones in the house and the lowest they will go is 50?! Does anyone...

All dense rockwool mineral wool no insulation under the slab or sides, every hole and crack has been spray foamed with a handheld can.

I have a 1500 sq ft shop, 28x52 with 10’ walls I have r23 in walls and r30 in ceiling I would of went more but have attic truss so only had 7.5” to work with. I live in upstate ny will a rinnai propane ex38 be too undersized? Or would I be better off going with a big maxx? How long would it take...

It’s white Metal so I wanted them to match recessed would look very nice but not easy

What is the easiest way without running pvc across the ceiling to cut my outlets out in ny new garage ceiling. I do not have the outlets in quit yet just the wire hanging. I still need to wire my outlets up and get the metal up. I have a couple for the openers and a couple for the lights as well...