Search results

Looking to purchase a polisher so I can polish and wax my car at home. I am a complete beginner when it comes to polishing. After talking to some people I was referred to products such as Meguiars Ultimate Polish and I was planning on trying Meguiars ultimate liquid wax. I just need a...

In the process of installing fiber cement siding on the garage. I've had a hard time getting the lower edge even across panels. I was able to flush trim the lower edge of the fiber cement siding to the bottom edge of the old wood siding using a flush trim bit on my router, but it left a bit of a...

Looking to build a new workbench soon. It will be mainly used for Woodworking and Automotive / Mechanic work. I’m set on the design I just need help picking an appropriate material for the top. I would probably use plywood, but the problem is a 4x8 sheet is $60. I’d like the top to be thick...

I plan on installing fiber cement siding on the outside of my garage. The panels will be installed vertically. Going over the old siding. See link for product details. I want the end result to look nice so I’m looking for advice on best approach to cut the opening for the electrical conduit...

Looking for an affordable air compressor for an upcoming project. I plan on putting up some fiber cement panel siding using a framing / roofing nailer. I’d also like the compressor to be used for some automotive and painting applications. Impact wrench, paint sprayer, spraying the underbody of...

Plan on installing fiber cement panel siding on the garage. Please see link for product details. I have a few questions. 1. Do I have to remove the old wood siding that is currently on the garage, or can I just go over it? See photo for current siding. 2. If I go over the current siding...

Looking to be some simple 3 ton jack stands. This would be to work on a sedan and a compact car. I purchased a nice Daytona floor jack from HF. I don't want to buy their aluminum stands. I prefer steel. I'm looking to spend around $50-60 for a pair of stands. Any Recommendations?

Looking for a code reader for under $100. This is for basic DIY / Weekend stuff. Reading and clearing faults.

Hello, I’m currently in the process of insulating the garage. I’ve come across a problem with the ceiling. The spacing on the ceiling joist aren’t standard. This is only a problem on the addition part of the garage. It’s a 10x20ft area. Please see photo for visual of what I’m referring to...

I inherited a HF Dust Collector. Item number 61790. During the setup I discovered that the switch is loose. It appears to be missing the key that would allow me to turn it on. See photo. Can I buy a replacement key for the switch? Can I replace the switch? Any help would be appreciated. Thanks

I am trying to find a replacement arbor nut for a Craftsman 351.221160 Table Saw. I don't have the nut that goes on the arbor. I measured the shaft that receives the nut and it measures as follows. The OD of the shaft is 5/8 (or 15.8/15.9mm). The thread pitch is 2mm. I attached a photo showing...