Search results

Wondering if any body has any experience using Permatex 85409. Looking to replace Oil pan gasket on a 2011 BMW 328 using Permatex 85409 Ultra Rubber Gasket Sealant & Dressing? It's suppose to condition the rubber and not harden. https://www.permatex.com/products/ga.../?locale=en_us...

Just as the title says. Looking for a 50A Power Inlet box recommendation to feed power from a generator. Thank you

Installing a sub panel in a attached garage which is finished. I would like the feeder cable in pvc in the garage for protection than having the Romex cable stapled on the wall. However there is not much room to run pvc conduit all the way in to the main panel (in Basement) and use THHN...

OK. I have updated my original post. It was late last night when I posted.... Hope the layout pic and the pdf for panel's break down is help full. I also have two other sub panels. One next to the main panel and the one for the pool #2 is on the opposite end of the house. I am looking to...

The gas tank is full of gas. It was filled day before the pump started acting up. I need to remove at least half the gas. I have read where you can not stick a tube down the filler tube due some screen in the way. Also the car is in the garage on the lift and I do not want the gas all over the...

What should I put under my four post lift legs to prevent rust from wintery mix. The pad is about 12x12". Pad is about 3/4" thick steel. Plywood would probably not work as it would soak up water. Any suggestions.... Thank you

Looking for a new Compressor to replace a 15 yr old 5hp/13 gallon Campbell Housfelt compressor. Looking for a standing unit as it takes less space for couple hundred dollars. I am a shade tree weekend mechanic. Use it from time to time for running pneumatic tools. Thx

Anybody use King KB2407 Electric Heater. It is similar to the Farenheat. Similarly priced except it comes with a remote control that has a built in Thermostat. Would like any feedback. Thx

Hello, Getting a four post lift soon:) and need to be use it in the Northeast winters... Looking to get a heater in 3 car garage in CT originally I was thinking about installing a Hot Dawg Propane heater.... Then a mini split heat pump was suggested. Will the heat pump be strong enough to heat...

Wondering if a four post lift can be pulled out on casters out of the garage by getting one post out at an angle and then second post and then again same thing for last two post assuming the lift is not too wide and tall. This is if I were to move locally I can have it towed on a Flat bed. My...

Looking for some recommendation for a four post lift installer in CT. I have not decided which one to get. Looking to also get the sliding jack as well. At the moment looking into Bendpak HD9xxx, DirectLift Propark 9 or Eagle Lift MS-XLT8000. Not sure if I need the extra length? Thanks

*** Two post Lift with base plate? Looking to aquire at a two post lift with base plate since I only have 10'11" ceiling clearance. One question I have is in the winter how do you clean the salt water around the base plate to minimize the corrosion from the salt water that drips from the car...

I am looking for heating options for three car garage 33wx23dx11h for the winters in CT. The garage is insulated three bay and the master bedroom is above it. I do have in ground 500 gal propane tank available. I work on my cars from time to time. Would like to make use of the winter months...