Search results

I'm in the middle of my shed/shop build. Working adding nailers for future cabinets/shelves/etc right now. I'm planning on sheeting the interior walls of the shop portion with 1/2" OSB and then painting it. My Dad used 8d galvanized nails when he did his. Said then you won't have to worry...

I put up a 32x64x10 pole building this summer. I have a divider wall up to cut the building in half to create a 32x32 finished shop and a 32x32 cold storage side. I will have a service door and a 9x8 overhead door on the divide wall to move snowmobiles, atvs, etc from side to side as needed...

When I sheet the inside walls of my shop I was going to get some steel J-trim to put on the bottom of the wall. I'd nail/screw it to my bottom purlin/plate and liquid nail/silicon it to the floor I figured that would help seal the wall from any water that may get to the wall...then let the OSB...

I was going to get a Mr. Heater Big Maxx 80,000 btu heater from Northern Hydraulics (on sale thru October). But then I was at Menards the other day and I looked at the Beacon Morris 75,000 btu unit they carry. It says Made in USA on it. Not sure where the Mr. Heater one is made. Anyone have...

Per my OSB thread I recently posted, I'm working on finishing the shop portion of my pole barn. I'm planning on getting a Mr. Heater Big Maxx 80,000 btu overhead heater. I'm planning on installing it in the corner over my front service door and aiming it at the middle of the opposite wall. I...

Per my OSB thread I recently posted, I'm working on finishing the shop portion of my pole barn. I'm planning on getting a Mr. Heater Big Maxx 80,000 btu overhead heater. I'm planning on installing it in the corner over my front service door and aiming it at the middle of the opposite wall. I...

I've got a 32x64x10 pole barn I just put up this summer. Cement work is all done, time to start insulating and sheeting the walls. I will be putting up a divider wall with a service door and overhead door in it. This will allow me to roll sleds, wheelers, etch from storage side (unfinished)...

Shortly I'm going to be working getting a service panel hooked up in my shop. I'm planning on running 100 amp service out there. In my house I have a Cutler Hammer CH service panel. My Dad recommended getting the same thing for the shop. It looks like the biggest 100 amp CH panel only comes...

We poured the floor in my 32x64 pole shed this week. Poured half Wednesday and the other half yesterday. The cement guy put in a construction joint between the two halves, with re-bar linking the two halves together. So basically each pour was a 32x32 slab. We used 4,000 lb exterior with...

I'm in the process of getting a quote to put up a 32x64x10 pole bar. I plan to have it cut in half, so 32x32 will be shop and the back 32x32 will be cold storage, with the intent to someday finish the inside. I'm planning on sheeting the ceiling with tin. The walls I'm not sure yet. I'm...