Search results

Craigslist find model# 152 221 240 it looks to be complete and in good condition. I payed the seller his asking price of $275. The motor sounds good, but I haven't cut anything on it yet. I was kind of disappointed that a lot of the parts have been discontinued and are not available from...

If you have the room install a standard 9'x7'. It will be less expensive than a smaller special order door and you will never wished that you had a smaller door. Good luck, Brian

Great job with the drain tile. Keep the ground dry and you won't have any problems with frost heaving your piers or floor. Brian

When I was young there where coal bins at the railroad siding. All the old row houses had a coal cellar under the front porch. They had to be filled with a scissor lift truck. A lot of those old coal fired heaters where converted to oil or gas and where used for many more years. I'd be willing...

Thanks for all the advice. Brian

Thanks Jim, I am going to flush the boiler like you said. Replace expansion tank and pressure relief valve. Then I need to replace the antifreeze in the system. If I remember correctly 5 gallons brought the protection down to -10f. Should I add the antifreeze to the empty boiler and then fill...

The boiler is a WEIL-McLAIN gold CGS-5 133,000 btu input. I just noticed that the pressure is 20psi while running. The tag on the pressure relief valve says 30psi. I'm really interested in flushing the boiler before I install any new parts. I do have a water well.The ph is on the soft side...

Where are you from Jim? I went to high school in Boyertown, PA

I opened the relief valve and let run into a bucket. I wasn't sure I was going to get it to close again. It shut off when I tapped the center pin. When I dumped the bucket I noticed some rust/scale in the water. Is there some type of flush I should be doing? This system has been in use since...

Highest point in the system is about 7' above the boiler. It is a standard cast iron boiler 84% efficient. How do you test the the auto fill valve? The gauge said 15psi without the boiler running. It doesn't leak all the time and when it does it's not that much. I had air at the schrader valve...

There is 15psi on the system. The expansion tank says 12psi pre charged and yes there is an auto fill valve. I guess that I should drain the primary loop and check the pressure on the bladder of the expansion tank. Thanks, Brian

Three years ago, I had to replace the expansion tank on my heating system. While he had it shut down, I also had him replace the pressure relief valve and air separator just for good measure. Now my pressure relief valve is leaking again. Could it be that my expansion tank has failed after only...

My house is only ten years old, Yet I have had to do expensive repairs to all of my major applances other than our range. I bought the parts wholesale and did the work myself or it would have cost more than a new washer. Even than it would have been cheaper and a lot quicker than remodeling my...

I just put $525 worth of parts into the same machine. Mine are built in with a counter over them. The new machines are all taller. These machines spin at a high rpm. The new assembly is the only way to go. Good luck, Brian

Good find, congradulations.

Great, cabinets! What type of plywood are they built from? Thanks, Brian

I liked the jump the shark reference. Ba Ba Boey, Ba Ba Boey.

Congratulations on being able to move in soon. Have you lived in the travel trailer all this time? Brian

Thanks, Jorge. Great solution. Are the red pieces on the right wall power outlets? Brian

Beautiful garage,top shelf craftsmanship. Can you explain why the stair needs to move? Thanks,Brian