Search results

Its been a while since I've had time to post on this. Getting the partial contractor done and gone was a chore. Work ethic around here isn't much:( I had to do the interior myself and am finishing the trim now. I have lights..bigtime! I asked the electrician to give be plenty of light and now I...

Brad, I have almost the exact setup. I have a few more light fixtures, 9 six tube. They are wired in 3's. If any one is switched on, all reception is gone! Someone must have a fix for this!! If the rf is that bad it looks like the fcc would be involved!

Did anyone find a fix for this? Just put in several T-5's and now my fm is gone! Thanks,:shocking:

Never noticed that I hadn't listed location on this forum. FIXED :bowdown:

Trusses were doubled on the right side of that picture. The bridging is 2x6 on the roof and 2x8 on the rafters. trusses are on 16" centers, walls are 2x6 on 16". The doors are copay double steel 9x12 on the end two and 9x10 on the side. They are up now and I'll take some more pictures tomorrow...

Things have been moving slowly. It's amazing that, with the building slowdown, its hard to get contractors to call back or show up when they tell you they are. Garage door guy was on time and working today though!

BIG X2 here! :thumbup:

I have 9 foot wide and 8 foot high doors on the attached and my F 1 fitty mirrors are a tight fit. Wife won't back it out. I'm doing 9 foot high and 12 foot wide doors on the new detached. That should do it!

And when they want to go for a ride...they have their way to let :thumbup:you know!

South Mills NC here. Welcome!

I think that you have found a way to make some money. Build stuff like that and sell it on ebay!!:thumbup:

The upper left corner is covered by the stair. It does provide light for the stairwell and the space under the stairs. I put the window there to "balance" the look from the outside.

With the sand, morter, oversize brick, steel, wall ties, nails, and labor it is close to 10 grand. The window treatment and corners ate up a lot of brick because you can only use a portion of each brick. It made a good match with the house though and looks like it belongs on the same lot. The...

Thanks! Pitch is 8-12

Thanks! The two large doors face south and the third faces north east. I should get good ventilation in the summer. One end bay is a wash/storage bay. The third bay will someday have a lift. I still have a ways to go and the weather here has been awful.

Thanks, I did brick to match the house because the garage is in front of the house. Thought it would look better that way.

Here we are now. first pictures are from yesterday. the rest from today. The brick is done after all of the weather delays! Now for the outside trim...if I can get that guy out here. Snow this weekend!

I’ve been looking at doors for my 30x40 project. I’ll need two 12x9 and one 10x9. Does anyone have an opinion or experience with the Clopay premium, Wayne Dalton 9100, or the Amar 3000 series? The Dalton is the thinnest but has the better insulation. It is also the less expensive. Thanks!

Here are a few from today. It's been COLD here since last week. The brick guy built a cover for the side of the building and heated it. It finally got to cold for them to work and for the morter. Since then the wind has torn down the tent. It worked while they were in it (60 degrees). The...

Go to cvo harley and do a search. A guy there did a nice one. :thumbup: