Search results

Can some one tell me what the taper is on the spindle of a current 1/2 milwaukee corded drill? If I end up buying a new one, the first think I'm going to do is swap the chuck. Thanks

This might be the hottest box in this entire thread.

I took some cuts today and no chips got close to it but the rates and chip load was pretty light. But ultimately, I think you're right.

New to me KR660/670B. Just finished cutting the drawer liners. Moved some stuff around to make a hole for it. Not sure if it's going to stay there. Don't want it to get covered in chips.

To follow on; Save the "tool queen" stuff till your mechanical ability has paid for your house. I've built a bunch of stuff with tools that didn't even have names on them. The street, dyno, farm or race track was never the wiser.

I don't know what wheel service is but I do own both tools. An air saw shares very few attributes with a sawzall. The air saw has has a short stroke, very fast recip rate and low torque. It's great for cutting plastic, fiberglass and sheet metal. But that's all. If you get one, buy a bunch...

Its important to note that there's a large continuum between the cman/ kobolt/ chicom junk and the conspicuous consumption of Snap On. High quality US and western European tools are pretty reasonable. You've got to make a little effort to source them. Proto, Williams, Wright, SK superkrome...

http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=370308322502&ssPageName=ADME:B:EOIBSA:MOTORS:1123#ht_917wt_941

I won't bump this again. Just really hoping to find these wrenches. Any help is appreciated. Thanks, W

I'm looking to buy two each of the Williams full polish, non supercombo 3/8 and 3/4" wrenches. They are Williams part number 1212 and 1224 respectively. NIB to "very good" condition. W

Pulling this up from the spring. Merkava, Can you rehost the pictures you referenced for detent on a K660? It woudl be appreciated.

Thanks for the info. I honestly cant say if the one you linked is right. All I have is a few bits of black plastic. No problem with the bump stops. It'll be a bit before I can take a pic of the slide but when I do I'll update the thread and PM you. Thanks

Very interesting... I wasn't able to find a part number on the Accuride slides but I'll look again.

I made Christmas come a little early this year. Finally found a KR660 and KR670 at the right price. Problem is that all the detents are blown out of it. Only thing left was a few pieces of broken black plastic. Not enough to figure out what they look like. Can any one match up a detent from...

That's tough to compete with. Beautiful piece. Some day...

First post, got to start some were; Three years ago I bought a 10K#, clear floor, ChiCom lift for a little less than $3K and I couldn't be happier. Dealing with your 11' height restraint it easy. During assembly, the columns are telescopic. Just push them up to with in an inch from the...