Search results

The heat pump is more efficient because it uses the electricity to move heat from a colder area to a warmer one. Heat is extracted from colder outside air, this heat is raised in temperature, and then the heat is dumped into the house...

What is with this human powered washing stuff. I have Gaya wash my car with natural organic rain. This makes up for my use of Benzine for cleaning carbs. Plus free Cancer!!:beer:

Very nice. I suggest a 2x4 or a 1x4 nailed and maybe glued to the underside of all the rafters between the winch and the pulley block. This will distribute the force over many rafters, and if you can make a tie in to the pulley block, it will remove the twisting force on the rafters. I don't...

Please do use a heat pump or mini split for the heat. There is a big multiplier in effectiveness for the electricity used.

Don't do that. The Tool Gods don't like it, and will punish you more in the future. To reduce stress, drink Jameson Irish Whiskey, none of that nasty peat taste which is really just like the insoles of hippie sandals.:willy_nil

Thank you atikovi and Ron Swanson for the information.

Even after google I do not know what a wheel simulator kit is. If you have a way of rotating or spinning the nut when grinding that would be good.

If it is pin drive one must put a small diameter punch in the socket hole to release the socket.

A very nice looking cabin. Well done.:beer:

There are pics online of anchors pulling out. May even be on youtube. It is rare but it does happen.

The human ones can be used to quench swords during the heat treat process. :thumbup::beer::willy_nil

If the drywall feels rough or scratchy after the primer, scuff sand it to knock off the rough ****. Paint will not hide them.

Well I get mine from Liberty Supply in Leominster MA USA. http://www.libertyweld.com/ I would ask at a place that supplies welding gases. A university should have some for the physics department. It is a fairly common item.

How about a dewar of liquid nitrogen? Pour that on the floor and that tar should turn to glass.

The water helps the foam set fully sooner. This type of foam cures with moisture.

Use a slip coupler. These have no *** or line to stop the tube half way. Make some mark on the tube or measure so you know when the slip coupler is centered over the cut.

As stated get the minimally expanding foam. Otherwise there will be much cursing when the jambs push and the door and windows cannot be opened.

Air post flow helps cool the torch head. 30 seconds post flow would be okay.

I take it you are single...

That is cheerful. Perhaps batteries are best charged out in the back yard under a metal trash can..