Search results

Tapmatic SPD-5. Made in USA tapping head. Original owner. Well maintained regularly oiled. Works flawlessly. Brand new tap jaws recently installed. ($40) Includes R8 Shank Straight shank Collet wrenches Two Stop bars. Selling because it no longer gets used. Will make any custom stop bar you...

Thanks guys Debating if i go 6L now or 10L I don’t need anything huge but 6L sounds pretty tiny

I’m looking to buy an ultrasonic cleaner to remove grease from bike chains. Is it worth buying a cleaning concentrate for $35 a gallon or is there equally effective, cheaper alternatives?

An ad for this caught my attention. Seems like it would be a pretty sweet tool for spot repairs on welds and whatnot. The tool itself does look a bit cheap though… https://blstrsander.com/

I’ll check it out I have an old 4” made in Japan craftsman that’s built amazing but it isn’t ideal spacing. I’d have to make an adapter plate to tabletop mount it.

Got my Langmuir arcflat table set up today. I’m wondering if it’s a bad idea to mount a 4”4” jaw vise off a bracket in the side of the table? The table is cast, sides are 5/16” top is 3/8” I’m mostly worried about breaking the casting. I don’t go crazy bashing anything on it.

There’s an air cooler by the compressor not shown here.

I’m probably being overly OCD but i moved my plasma table so I moved the air lines. The red square will be the plasma cutter the air has to run to. Currently off that distribution block the red hose goes to the plasma, it used to be a couple feet from it so i have to change it no matter what...

The table is by the door. Part of the table will be used for a tapping arm, a good 2x3 section will get lost to that,

Nieko

10’x18 probably. lol

You are not the target consumer…

My hands. I only keep 24x48 sheets up to 1/4”. If it’s larger it’s usually a small half sheet for a special one off item etc. I wish it was $450 now. Lol

Had no idea a new one even existed. Looks like they stopped including a cover, which i took off mine anyhow. And added a water separator.

lol I’ll keep you in mind. It cost about $3500 to build. (With brand new tooling) And it definitely has its quirks. The tooling was probably $1300.

I own the Eastwood for 3-4 years now. Running a cnc plasma. Works very well, have to replace the start capacitor every so often and air filters. They’re both under $15.

Spruced up my shop model a bit more. I really like the idea of this layout it’s just a matter of which table now. Shopsabre who now owns Langmuir, has on their site listing a 3x6 arcflat kit for $2115 with legs. Which probably includes two sets of the combining bolts ($70) and the leg kit that...

I put my deposit down the day of the PRI show and i already have a homemade hydraulic setup. The people saying use a swag and save money have no idea the value of a cnc press brake. The fact that this is compact and single phase, game changing potential. It will likely be about $8000 shipped...

Buildpro is nice but too big and no reason for added expense. Also, i want the front and side clamping walls. This is what I’m dealing with, i drew the arcflat from scratch. Black cube is small press brake Corner is plasma table Big green cube is drill press Small green cube is belt grinder...

A few people mentioned those to me. I really need the full 3x6 size and my second problem is I’m in a small space, to maneuver a 500+ lb single slab of cast iron is going to be a challenge. This is going to be a general use table for welding grinding etc. i don’t see the nitrate coating on the...