Search results

There's a 749/999 without the fairing in the back too! Nice bikes he's got there. Sent from my iPhone using Tapatalk

Started putting my friend's Yamaha Seca II back together after him having the frame powdercoated. Got the front end, swingarm, and engine assembled to the frame.

Got two more sheets of OSB up. Not have the bottom 2 feet left on the wall. Concrete guys also came by today to cut the slab and backfill gravel in the driveway. Sent from my iPhone using Tapatalk

Got an additional slab poured in front of the garage today! Also got two more pieces of OSB up on the wall in the garage.

Got 2 sheets of OSB up on the wall.

Here's mine. This is not original to the property (as seen by the block foundation). Not exactly sure of the age of it. It was a granary barn. I'm planning on redoing the siding with metal siding and running some power out to it. Upstairs.

Put up a patch panel where an old AC unit was. Just need to caulk the seam and get some paint on it.

Mounted up the new speakers in the garage. Waiting for some wire raceway to come to clean it up behind the TV.

Got all the new outlets in. Have them spaced at most 4' apart on all walls. Each wall is on it's own circuit.

Got the rest of the conduit up in the garage this weekend. Just need to pull the wire now and get the outlets hooked up.

Motorcycle surgery. It holds my auxiliary gas tank bottle.

Got the old electrical/conduit taken down and all the trim painted. A couple spots I need to touch up.

Started putting up some of the conduit.

2005 525 EXC setup supermoto.

Got a piece of trim up and replaced the piston seal on the clutch slave cylinder for the KTM.

I used foam baffles on my single-bay side of the garage. Had to cut them a bit to fit around the 2x6 joists.

I'll probably do that once I finish off the other side of the garage and get the walls painted with the exterior latex. I'm thinking I'll have to buy some more latex to finish the ceilings.

I also used the traditional Kilz Oil primer and then went over it with a latex based exterior paint. Used 2 coats of Kilz only on the ceiling

Got a coworkers ZX11 running after it had been sitting for 5+ years. Also started painting some trim for the garage.

Got the access pointer mounted in the single bay.