Search results

I know you said nonreversable but I really like my channellocks Sent from my SM-G930V using Tapatalk

I wouldn't glue since you'd basically be gluing to the paper on the sheetrock. 2.5" will be fine Sent from my SM-G930V using Tapatalk

Look at a JET. Last I looked reviews were good. My dad has a jet table saw for cabinetry and they love it. Sent from my SM-G930V using Tapatalk

I would just pack dirt around. Really doesn't matter because it going to be for looks really Sent from my SM-G930V using Tapatalk

Lots of hand work, trust me I know. I've actually been restoring about 6 disston saws the past few weeks. I like to put tung oil and buff in carnauba wax. Turns out great while keeping the natural colors of the wood. I have a buffing wheel for the brass screws which takes a couple seconds for...

Hmm could you set some J bolts in when you pour. Turn the bottom of the J towards the concrete Sent from my SM-G930V using Tapatalk

As itsnemo said, you should go with stick built if you want to keep the temps in that range. Metal buildings are usually cheaper depending on where you live, but at the cost of garbage efficiency ratings, plus I just wouldn't have a metal building. Sent from my SM-G930V using Tapatalk

Any Norton brand stuff. 3M is good also Sent from my SM-G930V using Tapatalk

The combo sander has been great. Had it for a few months and it's doing well, but I wish the backing plate on the disk sander was steel and not aluminum. PASS The sheets of sandpaper. Absolute garbage. 2X FAIL Sent from my SM-G930V using Tapatalk

. Sent from my SM-G930V using Tapatalk

Another Disston restoration. As far as can find this is a pre-1928 no. 16. Pictures 1-3 are before and 4-7 are after. Sent from my SM-G930V using Tapatalk

As @itsnemo said you are much better off with a wood frame and shingled roof. Metal buildings are a pain in the rear later down the road with repair/maintenance. Sent from my SM-G930V using Tapatalk

Citristrip stripping gel. Not to hard on the wallet and it works very well if you follow the directions Sent from my SM-G930V using Tapatalk

Just want to see what's out there. Looking for dewalt 20v circular saw 7-1/4". Sent from my SM-G930V using Tapatalk

Thanks for the link I will have to check that out. My grandad has about 12 hand saw hanging in his shop (mostly disston I think), where the vast majority were his dad's. Sent from my SM-G930V using Tapatalk

Thanks. I'm going to start on another one now. This time I will be sure to have before and after pictures to post. Should have it finished by the end of the week. Sent from my SM-G930V using Tapatalk

Thanks. My dad gave me 2 of his earlier to redo so I should be pretty busy tomorrow. Sent from my SM-G930V using Tapatalk

So i didnt see a thread for this so i made one. Any way I restored a couple of disston saws today. Refinished the handles and sharpened them. I wish I had took before picture but I forgot. I'm not sure what model the first one is but the second is a D-23. Sent from my SM-G930V using Tapatalk

Update on my vise Sent from my SM-G930V using Tapatalk

Pliers I stick with channellock and Klein Sent from my SM-G930V using Tapatalk