Search results

Well I guess will think about this for a while and move on to next project. Thanks for all the replys

I have 2 dp's with morse taper

Picture

I picked this up at scrap yard. I do not have the machine it went into

The arbor is not threaded

There is no screw on inside of chuck. No do not have a bearing separator. So it does have a taper? Do you have to drill or can you just press out adapter?

Can someone tell me how to remove this chuck. Would like to use it in a small drill press. Is it tapered or threaded. I do not have a set of wedges if tapered. I see it says 11N2 JT. Thanks for any help. Bill

Looking for a base for 724A Athol ratchet vise Let me know if you have one in your vise parts bin Thanks . Bill

I'm not restoring it just clean up and get it working. You never know who may need parts

Very nice work!!

Not when it's below 0° for another week and 20" of snow on the ground 🤪

-5° today but went to scrap yard anyway. Found this Anthol vise. Had repairs and pretty rough but want to try and save. Patent date on swivel base is Sept. 3 1912. Not sure of model as it has been brazed on label . Something 24A. ,4" jaws. Not sure if handle is original as that has been brased...

I would not buy one This came from scrap yard for free so I am out nothing

Figured it out clutch and gear froze on shaft Easy fix. Gear that chain goes on unscrews But pawl stays in place to hold load

Anyone worked on one of these cheap foreign small chain hoists? Chain goes up but will not go down. There is a pawl inside that clicks on ever notch for holding but doesn't have a lever to move to disengage pawl. Could use some help on this if some has had this issue. Maybe someone has the...

Chuck was just threaded to spindle Thanks for all suggestions and pics And likes. Will post pic when completed

Started cleaning and sand blasting parts to remove old paint and rust. Need a little help with getting chuck off spindle. Has a set screw which I know has to be removed. So then unscrew knurled nut? Does it push Chuck off? Thanks for any help with this issue. Bill

If your asking about the grinder it was completely taken apart and sand blasted. Painted with Ace hardware grey with brush. As for the stand, that also came from scrap yard. Had a really large and beat up 3 phase grinder that did get scrapped. I cleaned the stand and put Penotrol on as I liked...

Just finished it. 10" black and decker from 40's or ,50's. Another scrap yard save. I am good friends with the owner so when "GOOD JUNK" comes in I get to pick through it

Sorry.. forgot to insert pics