Search results

You could also pad out an area behind where the box is going to go, then fasten an old or new work box through the back into the blocking. A 2 x 4 on the flat and a 3 or 3 1/2" deep box will get you close to where you want to be. An additional 1/4 or 1/2" plywood shim could be added after the...

Put a 1/4” hole in the discharge pipe just before it leaves the pump chamber. The uphill pipe will self drain back to the chamber as soon as the pump stops.

I've been using the battery band saws for years. Very handy tools. I have never used them, but they do make battery tools specifically for cutting threaded rod.

I have both the Milton and the Snap-on. I use the Snap-on every time. Great gauge.

No. None. That's my point. I wouldn't be working with someone I didn't trust.

Why would someone contract with a builder that they don't fully trust?

That could have been done better in so many ways.

Fill the tank with Helium and float it out. Keep a string on it just in case.

I realize there is no off position in a properly wired three way switch. I used the word "off" in quotes because that was the term the OP used.

What happens if you try to reset the breaker with the switch in the "off" position?

Yes, that is correct.

10/2 is all you need. 30 amps, 120 volts.

The one I have is 30 years old and is still in really good shape and is now used by the grandkids. A little silicon spray will help speed up the ride to the bottom. :)

Looks just like the slide on an older Rainbow Play system.

Nice car. I spent a lot of time wrenching on a '63. Engine, transmission and trans axle all come out as unit from below. With the wheels off I would lower the car down resting the oil pan on to a wheeled cart. Pull the drums, remove four bolts on the carrier bearings, slide the axles out...

Spend some time sitting in different models and series to get a feel for the size. I really liked the size of the JD 3 series. I think it's impossible to get one tractor that will be perfect for every task.

Another vote for 33

I've been looking at the R2 Edge Tamers. They look like a quality product.

I'd also guess dirty slip rings.

Quick estimate to change a panel only, 4 hours labor, $600, double that number to cover material, $1,200 total. Or, figure $600 to cover material, same number to cover labor, $1,200.00 Location and what material used will change the numbers but I've found if you know what one of the numbers...