Search results

yes they are http://www.dixon-ztr.com/node2087.aspx

I change my own oil, I also rotate the tires and inspect the brakes while the oil is draining as well as roll around under there looking for anything thats not right so far I have found a leaking front axle seal on my TJ and a clean spot the front drive shaft on my dodge where the wires to the...

I would like to see the build up I have a AR-15 receiver that is waiting to be built, I plan to start on it after I get all the house projects knocked out

http://www.mcmaster.com/ page 2200 is feeler gauge stock it is just flat but you could bend the end if you need to 0.3mm = 0.011811in if you used the 0.012 in your set you would only be too big by 0.0048006mm

there you go cheaper and you dont have to do any work

http://www.mcmaster.com/ item# 8782K36, 2932A23, and 5699K62

on the drill bit there is a flat plate that is mounted at an angle, it kind of acts like a rudder inside the drill bit there is a beacon that transmits a signal to a tracker that displays the depth, pitch and roll angle of the drill bit the roll angle is how the drill bit is steered, 12 o’clock...

over the years I have bought 3 differant sets of screw drivers I now have a drawer full of screw drivers and there are only 2 that get used 98% of the time a 3/16 slotted and #1 phillips when these 2 get worn out I plan to replace only those two with better quality screw drivers instead of...

March 2nd 1836

9-37250: 3 blades and a replacement anvil 9-37252: 5 blades yeah I was about to throwout the package till I saw those part numbers and thought I better save this till I write down those numbers somwhere

well I went over to the local sears store and picked up the "Accu-Cut" it is the same thing as the "Handi-Cut" but it also has a wire cutter and the anvil retacts exposing the tip of the blade to be used as a utlity knife I cut some 1/4 inch fuel line with it and it worked great, well worth the...

What tools do yall use to cut rubber hose such as fuel lines and heater hoses? I have always just used my pocket knife which works but the results are not that great. So what would the best tool to get for clean straight cuts on rubber hose?

the shows I watch are: Classic Car Restoration Classic Rides Two Guys Garage Weekend Mechanic Power Block Shows Gearz

Is it going to be stationary or do you want it to be portable? If it will be stationary and you want it out of the way you could get 2 or 3 of these 10 gallon tank they are so cheap you could buy 9 of them for a little over $300 mount them on shelf up out of the way, to ceiling or in the...

Proto makes 12 pt impact sockets also MSC

try some of this stuff http://www.amazon.com/DuPont-Multi-Use-Lubricant-Fluoropolymer-Aerosol/dp/B00030BFEW it is dry so dust wont stick to it

from looking at those crappy pictures it looks like the bottom of the housing is different where the lever is on the newer ones why don’t you just take a piece of material (wood, plastic, what ever is laying around) and epoxy it onto the switch so it extends down so you can flip it with your...

http://www.shopfloortalk.com/forums/showthread.php?t=7469 this is the best one I have seen

looks good what is the pitch of the roof and the pitch of the vault?

Actually they would only be $0.055556 each and for $2 each on ebay you could make $17,500 profit if you could sell them all